Sony Ericsson HBH-35 Reference guide

This is the Internet version of the user's guide. © Print only for private use.
English ................................. 3
Deutsch.............................. 17
Español .............................. 33
Français ............................. 49
Italiano................................ 65
简体中文 ............................. 81
Declaration of conformity 95
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.

This is the Internet version of the user's guide. © Print only for private use.

This is the Internet version of the user's guide. © Print only for private use.
3
English
Introduction 4
Preparing the headset 5
Using the headset 9
Troubleshooting 12
Additional information 13
Declaration of conformity 95
Sony Ericsson HBH-35
First edition (March 2003)
This manual is published by Sony Ericsson Mobile
Communications AB, without any warranty. Improvements and
changes to this manual necessitated by typographical errors,
inaccuracies of current information, or improvements to programs
and/or equipment, may be made by Sony Ericsson Mobile
Communications AB at any time and without notice. Such changes
will, however, be incorporated into new editions of this manual.
All rights reserved.
©Sony Ericsson Mobile Communications AB, 2003
Publication number: LZT 108 6454 R1A
Some of the services in this manual are not supported by all
networks. This also applies to the GSM International Emergency
Number 112.
Contact your network operator or service provider if you are in
doubt whether you can use a particular service or not.
BLUETOOTH is a trademark of the Bluetooth SIG, Inc. (Special
Interest Group). The Bluetooth trademarks are owned by
Bluetooth SIG, Inc. USA.

This is the Internet version of the user's guide. © Print only for private use.
4 Introduction
Introduction
The Bluetooth™ headset HBH-35
is a portable headset solution
based on Bluetooth wireless
technology.
See “Guidelines for safe and efficient use” on
page 13 and “Limited Warranty” on page 15 before
using your headset.
What is Bluetooth wireless technology?
The Bluetooth wireless technology makes it possible
to connect any compatible portable and stationary
communications device without using cables. The
technology is based on a radio link that offers fast and
reliable transmission of voice and data information. It
does not require a line-of-sight connection in order to
establish communication. Bluetooth wireless technology
uses a globally available frequency range intended to
ensure communication compatibility worldwide.
How can I use my headset?
You can connect your HBH-35 headset to your mobile
phone or PC – or any device with Bluetooth wireless
technology that supports the Headset profile and the
Handsfree profile. This user’s guide focuses on how to
use the headset with your mobile phone. You need to
have a phone with built-in Bluetooth capability, or a
phone with a Bluetooth adapter connected to it. When
the headset is connected to your mobile phone, you can
use voice control to make calls (if your phone supports
this function). The phone can be tucked away in your
pocket or in a bag. You can handle incoming and
outgoing calls, and adjust the volume, using the
buttons on the headset.

This is the Internet version of the user's guide. © Print only for private use.
Preparing the headset 5
Preparing the headset
To be able to use the headset together with a mobile
phone, you need to have a phone with built-in
Bluetooth capability, or a phone with a Bluetooth
adapter connected to it.
Front
Back
Car holder
Use the adhesive tape on the
back of the car holder to fasten
it to the dashboard in your car.
Call handling button
Volume up
Volume down
Indicator light
Microphone
Charging connector
Speaker

This is the Internet version of the user's guide. © Print only for private use.
6 Preparing the headset
Getting Started
Before you start using the headset with a phone or
other device for the first time, you should:
• Charge the headset battery, using an appropriate
Sony Ericsson charger.
• Pair the headset with a device, for example,
a mobile phone.
Charging
The headset comes with a built-in rechargeable battery.
The battery is not fully charged when you buy the
headset. We recommend that you charge the battery
until the headset indicator light turns green before
using the headset for the first time.
• To remind you that you will soon need to recharge the
battery, the headset indicator light flashes red when the
headset is on.
• It takes 1 to 1.5 hours to fully recharge the battery.
• During charging, the indicator light shows a steady red
light if the headset is turned off, and flashes red if the
headset is on.
• When the battery is fully charged, the indicator shows
a steady green light if the headset is off, or a flashing
green light if the headset is on.
Compatible chargers
You can attach the following Sony Ericsson or
Ericsson chargers to the HBH-35:
• Travel Charger CTR-10
• Standard Charger CST-13
• Cigarette Lighter Adapter CLA-11
To charge the battery
• Connect the charger to the headset and to the mains.
Make sure the flash symbol on the plug faces the speaker.

This is the Internet version of the user's guide. © Print only for private use.
Preparing the headset 7
To disconnect the charger
• Tilt the charger plug downwards to remove it.
Turning the headset on and off
To turn the headset on
• Press and hold the button until you hear a short
low tone followed by a short high tone.
The headset indicator light flashes green. If the battery
is low, the light flashes red.
Note: The first time the headset is turned on, the
headset indicator light flashes green and red,
indicating that the headset is ready for pairing.
To turn the headset off
• Press and hold until you hear a short high tone
followed by a short low tone. The headset indicator
light is switched off.
Pairing the headset
Before you can use your headset, you must pair it with
the device you want to use it with, for example, a mobile
phone. Once you have paired your headset with the
phone, you do not need to pair it again until you want
to use it with another phone.
Pairing instructions
You pair the headset with the phone by adding it to a
list of paired devices in the phone. They then recognize
each other when they connect.
To pair the headset
1. Prepare your phone according to the phone’s user
documentation on pairing.
2. Press for up to 10 seconds until the indicator
light on the headset flashes green and red. The headset
is now ready for pairing.
3. Continue according to the instructions in the phone’s
user documentation. The headset passkey is 0000.

This is the Internet version of the user's guide. © Print only for private use.
8 Preparing the headset
Resetting the headset
You may want to reset the headset to its default
settings. This also clears all current pairings.
To reset the headset
1. With the headset turned off, press and hold for
up to 10 seconds until the indicator light on the headset
flashes green and red. Then release the button.
2. Press and hold again until you hear two beeps,
followed a moment later by a single beep. The headset
is now turned off. Keep the headset off for at least 30
seconds. The headset has now been reset.
Right or left ear
If you want to wear the headset on your left ear, you
have to change the orientation of the ear hook.
To adjust the ear hook for left-ear use:
• Turn the hook 180 degrees.

This is the Internet version of the user's guide. © Print only for private use.
Using the headset 9
Putting on the headset
1. Put on the headset with the ear hook behind your ear.
2. Make sure the microphone is pointing towards
your mouth.
Using the headset
Once you have paired the headset with your phone,
you can make and receive calls using the headset as
long as it is turned on and within range of the phone –
up to 10 m (30 ft) outdoors or up to 5 m (15 ft) indoors
with no solid objects in between. For best performance
use the headset and phone in the same room.
If your phone supports voice dialling and it is
activated, you can use this feature with the headset.
The following instructions cover the use of the
headset with a Sony Ericsson or Ericsson phone with
built-in Bluetooth capability, or with a Bluetooth phone
adapter from Sony Ericsson.
Note: Always make sure the Bluetooth Operation mode
in the phone is on when using a Bluetooth headset.

This is the Internet version of the user's guide. © Print only for private use.
10 Using the headset
Making calls
Phone functionality is still available when the headset
is connected. You can make a call with the phone or
with the headset.
To make a call using voice dialling
1. Make sure the phone and the headset are on and within
range of each other. Press .
2. After the beep, voice dial as you normally would.
If using the Bluetooth phone adapter: Say the voice
command after the phone beep (not after the headset
beep). To know when the phone beeps in relation to
the headset beep, make a test call using voice dialling.
3. End the call by pressing .
You can also make a call using the phone’s keypad
or phone book (if, for example, your phone does not
support voice dialling).
Answering calls
To answer a call using
1. When the headset rings, press .
Note: If the phone rings first, wait until the headset
rings, then press .
2. End the call by pressing .
To answer a second call
• You have to use the phone keypad to answer and
handle a second call, but you can still use the headset
for talking and listening. You cannot use the headset
buttons during a second call. Refer to the phone’s user
documentation on how to handle more than one
call simultaneously.
To reject a call
• When the headset rings, press and hold until you
hear a long beep.
To turn off the microphone
• During a call, press and release both and
to turn off the microphone. A repeated beep is heard
while the microphone is turned off.
• Press and hold both and again to resume
the conversation.