Important Safety Instructions
-PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS
IN
THIS OWNER'S MANUALAND THOSE MARKED ON THE UNIT. RETAIN THIS
BOOKLET FOR FUTURE REFERENCE.
This set has been designed and manufactured to assure personal safety.
Improper use can result in electric shock
or
fire hazard. The safeguards
incorporated
in
this unit will protect you if you observe the following procedures for
installation, use and servicing. This unit is fully transistorized and does not contain
any parts that can be repaired by the user.
0 X
I \
~
.4
DO NOT attempt to operate if picture fails or no sound
is
heard. Stop using the unit and turn it off immediately if
there is any smoke or burning smell.
If
unit is damaged,
it could cause fire or electrical shock.
This product
is
designed for DC 12V.
It
is recommended
to check with a trained "Authorized Dealer" for using this
unit in a
RV,
truck or bus application.
DO NOT install unit where it may obstruct driver's sight or
cause possible injury to passengers.
DO NOT allow installation to interfere with normal vehicle
operations. Wiring and installation should not interfere with
the brake pedal, steering wheel or transmission shift lever.
DO NOT remove any screws or hardware from vehicle to
install products.
ctJ
o 0
~PQ
~~
0o
f
ccJ
0 v
Inspect any vehicle areas before drilling any holes for
mounting or wiring of unit. Make sure to check behind
installation area to prevent damaging any existing vehicle
wiring or other connections. Failure to do so could result
in vehicle malfunction or impaired vehicle operation.
All wiring must be routed safely and should not distract
the driver's attention during normal operating conditions.
DO NOT allow wiring to interfere with operation of the
vehicle's brake pedal, shift lever or steering wheel.
DO NOT cut or modify any DIN cables with fuse built-in.
This could render such protective circuit inactive and
potentially result
in
permanent damage to the unit or
vehicle.
Make sure both DIN cable and other wiring is not run
where it may be cut
or
damaged.
The slots and openings in the unit is provided for nece-
ssary ventilation. These must not be blocked to ensure
reliable operation.