Speco VLDT4W User manual

!ITEM №: VLDT4W/VLDT4G
!Caution for Installation
1. In order to prevent electronic shock, don’t loosen any screws or covers.
2. Do not directly touch the front glass. If necessary, use a soft cloth
moistened with alcohol to wipe off the dust.
3. Avoid places where there are frequent vibrations or shocks.
4. Don’t operate the camera beyond its temperature, power source
ratings.
5. When any abnormalities happen, make sure to unplug the camera and
contact your local dealer.
!Packing
1. Camera X1
2. Junction box X1
3. User Manual X1
4. PWA 4*25 Screw X3
5. KM 4*10 Screw X3
6. PM 4*12 Screw X4
7. Junction box cotton pad X1
8. Camera cotton pad X1
9. Ф8.3mm rubber ring X3
10. Plastic-Conical-Anchor X3
11. Hexagonal Wrench X1
12. Mounting drawing paper X1
!Specification
ITEM
VLDT4W/VLDT4G
IP Rating
IP66
Type
Removable IR Cut Filter
Signal System
NTSC/PAL
Pick Up Device
1/2.9" 2.2 Mega Pixels CMOS
Picture Elements
1920(H)X1080(V)
Min Illumination
0Lux with IR LED 12 pieces
S/N Ratio
≥52dB
Lens
3.6mm Board Lens
3D/2D
ON
SENS-UP
ON
IR SMART
ON
White Balance
ATW
Back Light Compensation
OFF
DWDR
ON/OFF
OSD
With UTC Signal(DVR Control OSD)
Video Out-put
HD-TVI/HD-AHD/HD-CVI/ CVBS
Power Supply
DC12V ±10%
Current Consumption
400mA（MAX）
IR Effect Distance
49.2ft (Outdoor)
Dimension
3.7”×3.15” inch
Camera Weight
330g (11.64oz)
Storage Temperature
-22～+140
Operating Temperature
-22～+104℉
Junction box
Dimension
3.7”×1.77” inch
Weight
230g (8.1oz)
Remark: Non-regulative adaptor may cause camera damaged.
Multi-Format HD Analog IR Camera

!video signal output switches

●Overview
Junction box cotton pad
M20 Plastic Screw
Junction box
Water-proof
rubber ring
Junction box upper cover
KM4*10 threaded
screws
●Installation
（1）
（2）
（3）
（4）
（5）
（6）
1．Drill installation holes according to drawing paper，
then stuff into rubber stoppers。
2．Paste cotton pad onto the bottom of junction
box，then push the water-proof rubber ring onto the
upper body of junction box。
3．Use 3pcs PWA4*25 self-tapping screws to fix
junction box body。
4．Use 3pcs KM4*10 threaded screws to fix
the upper cover with the junction box body。
5．Disassemble the dome base，put the
cotton pad onto the upper cover，then use
4pcs PM4*12 screws to fix the dome base
with the junction box。
6．Connect all cables and
put them into the junction
box ，then install the
dome with the dome base
well，then use the dome
ring to fix。