Sport-thieme Trolley User manual

Assembly instructions
Trolley
for Free-Standing Goals
Art.-Nr.: 230 7204
0218214 · © 2018 Sport-Thieme GmbH
D-38367 Grasleben ·Germany
sport-thieme.com · info @sport-thieme.com
Phone: [phone] · Fax: [phone]

2
Assembly instructions for Art.-Nr. 230 7204
1. Scope of delivery
Please check the following content before assembly.
Contents:
1x Aluminium basic frame
3x Guiding roll
1x Accessories
1x Assembly instruction
Accessories:
12x Hexagon socket screw M10 x 25 mm DIN 933
12x Washer Ø 10.5 mm x 30 mm, DIN 125
12x Self-locking nut M10, DIN 985
3x Plastic cap 80 x 40 mm
2x Belt strap with buckle

3
Assembly instructions for Art.-Nr. 230 7204
2. Assembly
The following tools are necessary:
- 2 wrench/ring spanners 17 mm
- hammer/mallet
a) Fixing of caps:
Use a hammer/mallet to insert caps in the 3 lateral
openings provided in the basic frame.
b) Fixing of guiding rolls:
Place guiding rolls at welded aluminium plates of
the frame. Adjust holes of guiding rolls and alu-
minium plates. Then stick per roll 4 washers Ø
10.5 x 30mm on 4 hexagonal socket screws M10
x 25 mm, DIN 933.
Now stick them from the top through holes of
aluminium plates and guiding rolls (see picture
bottom left). Screw from the bottom self-locking
nuts M10, DIN 985 and tighten them (see picture
bottom right).

4
Assembly instructions for Art.-Nr. 230 7204
3. Transport of the goal
Lift the goal and push the trolley under one ground bar between the lateral guiding rails. The balance point has to be in the
middle of the trolley. Fix the bar of the goal with two belt straps by pulling them through the welded plates from the bottom of the
frame. Pull the belts through the buckles and tighten them (see pictures bottom left and right). Then lift the goal at the other side.
It is possible to move in all directions (see picture bottom right). Normally one trolley is sucient to transport a goal. In case of
big and heavy goals we recommend to use two trolleys which have then to be pushed under both bars.
4. Maintenance and safety instructions
Check screwed fastenings regularly and change damaged and wearing parts if need be.
Take care that sloped surfaces may influence the balance point of the goal so that during
transport you have always to observe the safe position of the goal.
The trolley is equipped with pneumatic-tyred rolls. Please check the pressure regularly.
Notice: Due to our continuous quality check of products and equipment technical modications are possible.
Only use water for cleaning the surfaces. Do not use alcohol or any aggressive chemicals!