Sport-thieme 233 7904 User manual

D-38367 Grasleben ·Germany
sport-thieme.com · info @sport-thieme.com
Phone: [phone] · Fax: [phone]
Assembly manual
1118205 · © 2018 Sport-Thieme GmbH
Art.-Nr. 233 7904
233 7917
Sport-Thieme®Wooden Plyo Box

2
Assembly instructions for Art.-Nr. 2337904/17
Unpack the 3 in One Plyo Box and make sure you have received all parts before beginning
assembly.
PARTS LIST:
2 Side Panels marked „A“
2 Side Panels marked „B“
2 Panels marked „C“ (Top and Bottom Panels)
1 Hardware pack
3 Internal Support Brace:
Make sure the arrow marking are on the outside of the Plyo Box.
Wood glue is highly recommended to use for assembly.
Step 1
Assemble on panel „A“ and one panel „B“. Be sure that the top edge of the two panels are lined up and straight. Secure it
using 3 screws into the pre-drilled pilot holes. Hand tight the screws about half way. Do not tighten the screws completely .
This will allow some play in the nal assembly for alignment.
Step 2
Once it‘s assembled, set it aside then assemble the other Panel A & B. Repeat Step 1.
Step 3
Assemble both halves together and onto the Panel „C“ (Bottom), using screws . Hand tight all screws.
Step 4
Assemble the internal Support Brace – see below. Tighten it using 1 Screw.
Step 5
Assemble the Top Panel (Panel „C“) using screws. Make sure all panels are straight
and aligned . Hand tighten all screws.
Side panel A
Side panel A
Side
panel B
Side
panel B
Top and Bottom panels C
Internal
Support Braces:
2
1
3
1
2
3
11
22
3
1
2
3
Screw
Internal Sup-
port Braces: