Sport-thieme 122 4362 User manual

Operating/assembly instructions
Ballet barre base
Sport-Thieme GmbH
38367 Grasleben / Germany
Tel: [phone]
Fax: [phone]
Prod. code: 122 4362
page 1 / 4
04/2016
!
!
Instruction manual for
the ballet barre base
Thank you very much for choosing a Sport-Thieme product. Please read the
instructions fully before you assemble the equipment so you can enjoy the product
and its guaranteed safety:
1. When you open the package, please ensure all the necessary parts are
included.
Pos.
Number
Description
1
1
ballet barre base
2
3
hex screw DIN 571 – 10 x 80
3
3
washer DIN 125 – A 10.5
4
3
wall plug
5
4
wood screw 5 x 25
6
2
ballet barre Ø 40 mm (not included!)

Operating/assembly instructions
Ballet barre base
Sport-Thieme GmbH
38367 Grasleben / Germany
Tel: [phone]
Fax: [phone]
Prod. code: 122 4362
page 2 / 4
04/2016
!
!
exploded view drawing
2. Assembly steps
Step 1

Operating/assembly instructions
Ballet barre base
Sport-Thieme GmbH
38367 Grasleben / Germany
Tel: [phone]
Fax: [phone]
Prod. code: 122 4362
page 3 / 4
04/2016
!
!
- Ensure that the base is mounted to a solid floor!
- Starting with the desired position for the base (pos. 1), mark the drilling
holes.
- Drill the holes using a suitable masonry drill bit and put in the wall plugs
(pos. 4).
- Now, put the three hex screws (pos. 2) with washers (pos. 3) through the
base’s holes and tighten them in the wall plugs using a hex key.
Step 2
- Screw the two ballet barres (pos. 6) to the base (pos. 1) using the four included
wood screws (pos. 5).
- In order to prevent possible chipping, the ballet barres can be pre-drilled
using a 2 mm wood drill bit if required.
- If several bases are used, determine the distances between them
individually according to your needs and dependent on the barres you have
selected. The distance should not be more than 1.50 m.
Caution: Do not overload or climb the equipment!

Operating/assembly instructions
Ballet barre base
Sport-Thieme GmbH
38367 Grasleben / Germany
Tel: [phone]
Fax: [phone]
Prod. code: 122 4362
page 4 / 4
04/2016
!
!
3. Additional information
Floor mounting:
use fixings suitable for your floor
to bolt the bases to the floor.
Load information:
the included fixings are suitable for concrete of
C25/30 quality and can take a tensile load of 0.5 kN.
max. load:
50 kg
Use:
this product is only suitable for its intended use.
4. Maintenance and care instructions
We are happy to answer any questions you may have.
Your
Team
Carry out a visual check at regular intervals.
Due to our continuous quality control of the products, technical changes
may occur which may lead to slight deviations in the instructions.
Check at regular intervals that the screw connections are tight.
Check the equipment for possible damage and replace worn-out parts.
Check the condition of padded elements as use can lead to signs of
wear.
!