ST&G P313A User manual

ST&G USA Corporation
www.stngco.com e-mail: [email protected]
2691 Saturn Street, Brea, CA 92821, USA
Tel : [phone] Fax : [phone]
Room No. 609, 43, Yangsan-ro
Yeongdeungpo-gu,
SEOUL, 07270, SOUTH KOREA
Tel : [phone] Fax : [phone]
e-01
LOT
Weight
Date of fitting
REP
Authorized Representative
MDSS GmbH
Schiffgraben 41
30175 Hannover, Germany
Instructions for P313A Pediatric 4 Bar Knee
With Manual Lock for AK and KD
1. Assembling:
Please assemble from socket to foot according to the illustration on “Appearance & Specifications”,
where B, D, E and F can be swapped to other components with same or similar functions. Since all
components can be assembled by screws and nuts, please arrange and position the matching
components and fixed with screws and nuts to complete the assembling.
2. Joint Adjustment:
According to patient’s weight and movement, please modify the friction adj. screw on the
connecting bar (#13) to increase/reduce the friction on the joint; modify the stability screw (#15) on
the linkage to increase/reduce the sensitivity of the joint; or to modify the adj. screw for extension
assistance (#1) on the piston tube to increase/reduce the elasticity of the spring. Pull up the fixed
bar (#24)○
1, the knee will flexible, release the fixed bar (#24)○ 2the knee will fixed. Pull up the fixed
bar (#24)○
1then fasten the fixing screw (#25), the knee will keep flexible condition.

ST&G USA Corporation
www.stngco.com e-mail: [email protected]
2691 Saturn Street, Brea, CA 92821, USA
Tel : [phone] Fax : [phone]
Room No. 609, 43, Yangsan-ro
Yeongdeungpo-gu,
SEOUL, 07270, SOUTH KOREA
Tel : [phone] Fax : [phone]
e-01
LOT
Weight
Date of fitting
REP
Authorized Representative
MDSS GmbH
Schiffgraben 41
30175 Hannover, Germany
1) Prepare the suitable stump sock and thin sock.
2) Put on the stump sock and thin sock according to the length and perimeter of the residual limb.
3) After put on the sock(s), use both hands to slip the socket (A) over the residual limb. Then,
please stand up for adjusting the socket to the correct position and buckle up the belt to walk.
4) To reduce the crimp and pressure on the residual limb during walking, please arrange the stump
sock and thin sock evenly until there is no crease.
5) During walking, the residual limb with the socket should be a straight line when the leg appeared
to be the upright position.
Take Off:
1) Loosen the belt.
2) Remove the socket from the residual limb and sit down.
3) Take off the sock(s) for residual limb in sequence.