Star Micronics PR921 Installation instructions manual

Mounting the Presenter PR921
1. Opening the Package : Check that all of the accessories are included.
2. Mounting Procedures :
2-1 Mounting the Lock Lever
Screw in the two lock levers into the presenter with
the two lever screws.
2-2 Mounting the Stopper
Screw in the stopper into the presenter with the
screw.
2-3 Mounting the Presenter
1Install the shaft in the presenter.
2Lay the release lever on the mechanism side down
and open the mechanism platen holder toward the
direction of the arrow.
3Position the screw holes, as shown in the figure, and
place the mechanism on top of the presenter.
4Fasten the presenter to the mechanism using the two
screws.
M3 × 6 screws (3)
(For Presenter/
Stopper Mounting)
M3
× 4 screws (2)
(For Loop Guide Mounting) Lever screw ×2 Lock lever ×2
Loop guide
Shaft
Stopper
Presenter
Lock lever
Lever screw
Mechanism
Release lever
Platen holder
Presenter
Mechanism
Presenter
Screw
80871281 PR921
Shaft
Stopper
Screw

5Lift the presenter in the direction of the arrow to
close.
6Close the right and left sides lock shafts with the
lock lever.
7It is recommended that the presenter cable be set in
the position shown in the drawing on the mechanism
side using the Fastener.
(Customers must supply the Fastener.)
Note: Set the Fastener after checking that the
cable is not pinched when opening or
closing the presenter.
8If a loop guide is necessary, mount it to the
mechanism using the two screws.
Mechanism
Presenter
Mechanism
Presenter
Screw
Loop guide
Lock shaft
Lock lever