StarTech.com SATDOCK22R User manual

Serial ATA Hard Drive Dock
USB to SATA External Dual Hard
Drive Dock with Stand Alone
Duplicator
SATDOCK22R
Instruction Manual

FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver•
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an
endorsement of the product(s) to which this manual applies by the third-party company
in question. Regardless of any direct acknowledgement elsewhere in the body of
this document, StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.

i
Table of Contents
Introduction..................................................................... 1
Packaging Contents.....................................................................1
System Requirements .................................................................1
Installation....................................................................... 3
Hardware Installation...................................................................3
Driver Installation.........................................................................3
How to Use ...................................................................... 4
LED Status ..................................................................................4
Buzzer Status ..............................................................................4
Specifications.................................................................. 5
Technical Support........................................................... 6
Warranty Information...................................................... 6

1
Introduction
The SATDOCK22R Dual Drive SATA Hard Drive Duplicator functions
as both an external SATA hard drive docking station for 2.5” or 3.5”
SATA 1.5/3.0 Gbps hard drives and a convenient standalone hard drive
imaging solution, delivering an exact 1 to 1 disk copy.
Packaging Contents
1 x SATDOCK22R hard drive dock•
1 x Power Adapter with US, UK, EU power cords•
1 x USB type A-B cable•
1 x Instruction Manual•
System Requirements
Available USB 2.0 port•
Available AC Power Outlet•
Microsoft Windows• ®2000/XP/Server 2003/Vista, Mac OS®X
or Linux®

2
Installation
Drive
Ejection
Button
Power
button/LED
Duplicate/JBOD
Mode button
Duplicate
Start button
Duplicate
Progress LED
Drive
Power/
Activity
LED
Drive Bay
(Source)
Drive Bay
(Destination)
Top View
Rear View
DIN Power
connector
USB type B
connector

3
Hardware Installation
JBOD Mode
Connect the external power adapter to the Hard Drive Dock.1.
Install 1 or 2 hard drives into the dock in either drive bay.2.
The Mode button LED should be blue to indicate JBOD mode. Press3.
and hold the Mode button for 3 seconds to switch modes.
Connect the USB cable from the hard drive dock to the computer4.
system.
The operating system should now detect the hard drive(s) and5.
make them available. The hard drives may need to be partitioned/
formatted using a disk management utility before you can access
them.
Duplicator Mode
Connect the external power adapter to the Hard Drive Dock.1.
Install 2 hard drives into the dock. Make sure to place the drive2.
with the data you want copied (Source) into the “Source” bay. The
destination disk (Destination) should be equal or larger in capacity
than the source disk.
The Mode button LED should be red to indicate Duplicator Mode.3.
Press and hold the Mode button for 3 seconds to switch modes.
Once both drives are installed, press the Start button to begin4.
duplication.
Driver Installation
Windows 2000/XP/Vista, Mac OS X, Linux kernel
No driver installation is required for these operating systems, as
this hard drive dock is natively supported, so the drivers are already
installed.

4
How to Use
LED Status
Name State Description
Drive Power/Activity
Blue Drive detected
Red No drive detected
Flashing Drive activity
PWR Off Hard drive dock is powered off
On Hard drive dock is powered on
Mode Blue JBOD mode
Red Duplicate mode
Buzzer Status
Mode Status Description
JBOD Twice per second,
every 8 seconds
Drive is removed while powered
up. No drives present.
Duplicate Long beep per
second, 3 times Drive detection failure.
Duplicate Twice per second, for
6 seconds
Drive duplication successfully
completed.
Duplicate Long and short beep Drive duplication error.

5
Specications
Bus Interface USB 2.0
External Connectors 1 x USB type B
1 x DIN power connector
Chipset Acard ARC286
Hard Drive Bays 2
LEDs
1 x Power
1 x Mode
1 x Duplicate progress bar
Hard Drive Compatibility 2.5” and 3.5” SATA 1.5 and
3Gb/s up to 1.5TB in capacity
Maximum Data Transfer Rate 480Mb/s
Duplication Rate 72MB/s
Dimensions 144.8mm x 133.6mm x 75.3mm
Weight 550g
Compatible Operating
Systems
Windows 2000/XP/Server 2003/
Vista, Mac OS X, Linux

6
Technical Support
StarTech.com’s lifetime technical support is an integral part of our
commitment to provide industry-leading solutions. If you ever need
help with your product, visit www.startech.com/support and access
our comprehensive selection of online tools, documentation, and
downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in
materials and workmanship for the periods noted, following the initial
date of purchase. During this period, the products may be returned
for repair, or replacement with equivalent products at our discretion.
The warranty covers parts and labor costs only. StarTech.com does
not warrant its products from defects or damages arising from misuse,
abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid
for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.

StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Server
Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
Visit www.startech.com today for complete information about all
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.