© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modications reserved.
Mounting instructions for swing „patis3“
Item No. 512013401
State: 10/10/2014 · S. 3 · MS/TSA
1:35
Mounting instructions for swing „patis3“
Diagram 3: Top view „patis3“
Concrete foundations
Size of the minimum space = safety area
The dimensions of the sketches relating to the use of natural sur-
faces with impact-absorbing effect.
When using synthetic safety tiles
will reduce the impact surface in the direction of swing
by 500 mm. The minimum space remains
preserved in its entirety.
5. Align swing in vertical and horizontal direction and keep it supported until the
foundations have bound off. Note: Make sure that the supported swing is not
used for playing.
6. After a setting period of 10-14 days, depending on weather conditions and
foundation size, seal the foundation with the safety cover required for the
height of fall indicated. Set up impact-absorbing playground surfacing accor-
ding to EN 1177 HIC 1000. Recommended surface material: grass, sand,
bark mulch, gravel, synth. fall protection. (Critical drop height ≤ 1000 mm)
7. Screw the chains with the swing seats onto the swing suspension. Readjust
the screws on the swing bars. Glue the caps to the tube ends.
8. Do not allow children to use the equipment before the installation has been
nished.
Attention: If the play equipment has been incompletely installed or partly dis-
mantled when carrying out maintenance and repair work, this may lead to par-
ticular risks of injury for the user. For this reason, make clearly visible that the
equipment shall not be used in such cases.
NOTE: Play equipment, which contain components made of stainless steel
should not come with „normal“ steel parts in contact. Those steel parts may rub
off and leave small steel particles in combination with moisture brown rust stains.
If such corrosion occur on stainless steel parts, they are ne with an abrasive
(240 grit) to remove.
Please take care when transporting and setting up the fact that the components
are made of stainless steel with no „normal“ steel parts in contact.
