STONEX R80 User manual

(April 2020)-Ver.1-Rev.0- Firmware Version V3.0.1.0 150228 www.stonex.it
STONEX R80
Motorized Total Station
Quick guide

Welcome interface
Switching on the R80, you
will see the interface on
the right. Click on:
•BSC measure to check
performance
functionality and
manage some
parameters;
•About to check the
software version;
•INST Setup to
manage the settings;
•Exit.

Basic Measure
In the Basic Measure
interface you can visualize
angles, distances or
coordinates.
In the top right corner,
current settings are
shown.
Select Param to manage
the units.

Instrument setup
In the INSTset interface
you can manage settings
of your Total Station.
To access them, enter the
password:
12345678
After selecting the option,
in each page, press
[Enter] to keep the setting
or press [Cancel].

Star settings
TiltXY
Press the [*] key to check
the electronic bubble and
to manage the
compensator.

Star settings
Target
Press the [*] key and click
on Target.
Here you can manage the
target type, the laser
pointer and activate the
Auto aim & Lock.

Star settings
Battery
Press the [*] key and click
on Battery.
Here you can manage the
reticle and guide light
illumination and switch
on/off the Bluetooth.

Shortcut keys
Look at the combinations
on the right to manage
some settings on the
Total Station.
Key
combination
Description
Power
on
★
Enter the setting mode directly/Turn on the
electronic bubble
α
Shift among number, small letter and capital
letter
FUNC+B.S
Turn on/off backlight of key panel in face left
position
FUNC+F6
Turn on/off backlight of key panel in face right
position
F7+F6
Start touch screen calibration
FUNC+F7
Turn on/off soft keyboards
FUNC+
▲
Increase backlight brightness of LCD
FUNC+
▼
Decrease backlight brightness of LCD
FUNC+
◄
Turn on/off LCD display in face left position
FUNC+
►
Turn on/off LCD display in face right position
F6
If
Prism is
set as target type, it activates the prism
search.

Touch screen
calibration
Press the [F7]+[F6] keys
(F7 firstly, then F6).
Carefully press and briefly
hold stylus on the center
of the target. Repeat as
the target moves around
the screen. After all the
targets are clicked, the
screen will display as left,
tap the screen to register
saved data.

Communication
The communication
modes available on the
Total Station are listed on
the right.
About Bluetooth, make
sure you have enabled it
in the Star settings.
USB dongle
USB-mini USB cable
Bluetooth
Password: 1234 or 0000

STONEX® SRL
Via dell’Industria, 53 - 20037 Paderno Dugnano (MI)
Tel : [phone] | Fax :+ 390278610299
www.stonex.it | [e-mail]