3
PART 2 • English
English
GENERAL PRECAUTIONS — SAFETY PRECAUTIONS
Lightning — If a lightning storm occurs while using a specified AC adapter, remove it from the wall
outlet immediately. To avoid damage from unexpected power surges, always unplug the AC adapter
from the power outlet and disconnect it from the receiver when the receiver is not in use.
Overloading — Never overload wall outlets, extension cords, power strips, or other power connection
points with too many plugs.
Foreign Objects, Liquid Spillage — To avoid personal injury caused by fire or electrical shock from
contact with internal high voltage points, never insert a metal object into the product. Avoid using the
product where there is a danger of spillage.
Heat — Never use or store this product near any heat source such as a radiator heat register, stove,
or any type of equipment or appliance that generates heat, including stereo amplifiers.
Servicing — Refer all servicing to qualified personnel. Attempting to remove the covers or
disassemble the product, could expose you to dangerous high voltage points.
Damage Requiring Service — If you notice any of the conditions described below while using a
specified AC adapter unplug it from the wall outlet and refer servicing to qualified service personnel:
1. Liquid has been spilled onto the product or some other object has fallen into the product.
2. The product has been exposed to water.
3. The product does not operate normally despite following operating instructions.
Adjust only the controls described in the operating instructions as improper
adjustment of other controls could damage the product and require extensive repair
word by a qualified technician.
4. The product has been dropped or damaged in any way.
5. The product exhibits distinct change in performance.
Replacement Parts — When replacement parts are required, make sure that the authorized service
centre uses only parts with the same characteristics as the originals, as recommended by the
manufacturer. Unauthorized substitution of parts could result in fire, electrical shock, or create other
hazards.
Safety Check — Upon completion of servicing or repairs, ask the service technician to perform safety
checks to determine that the product is in good working order.
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as
vases, shall be placed on or next to the apparatus.
Where the mains plug or all-pole mains switch is used as the disconnect device, the disconnect
device shall remain readily operable.
Remote control transmits a directional infrared beam. Ensure to aim the remote control directly at the
infrared sensor of the unit during operation. If the sensor has been covered or there is a large object
between the RCU and sensor or it is exposed to direct sunlight or a strong artificial light (fluorescent
or strobe light) the sensor may not be able to receive the remote signal. In this case, change the
direction of the light or reposition the unit.
1.2 Storage
Your receiver and its accessories are stored and delivered in a packaging designed to protect against
electric shocks and moisture. When unpacking it, make sure that all the parts are included and keep
the packaging away from children.
When transporting the receiver from one place to another or if you are returning it under warranty
make sure to repack the receiver in its original packaging with its accessories. Failing to comply with
such packaging procedures could void your warranty.
