Subaru EyeSight User manual

EyeSight Limitations*
The stereo camera lenses are precision components. When the system detects that the
stereo camera lenses are dirty, no EyeSight functions will be activated.
Always observe the following precautions:
• Do not touch or try to clean the EyeSight camera lenses inside the vehicle. Extra precaution
should be used when cleaning the inside of the windshield. Over-spray from cleaners may
impair or even damage the cameras’ lenses.
• Do not attempt to remove or disassemble the stereo cameras.
• Do not attempt to change the position where the stereo cameras are installed or modify any
of the surrounding structures.
• Do not install any interior rearview mirror (such as a wide-type mirror) other than a genuine
SUBARU rearview mirror. Also, adjust the rearview mirror so it does not obstruct the stereo
cameras. Failure to do so may affect the stereo cameras’ field of vision and could prevent
the EyeSight system from functioning properly.
For more detailed information, please consult your EyeSight Owner’s Manual.
• The EyeSight system needs time to recognize an object or potential obstacle. When the
vehicle speed differential with an obstacle in front is greater than approximately 20 mph, it
may not be possible to avoid a collision.
• Sun glare, inclement weather such as heavy rain, snow or fog, or a dirty windshield will
hinder EyeSight operation. A cracked windshield, oil film on the glass or reflections may
impede EyeSight performance. In these conditions, EyeSight may not operate properly or
EyeSight may temporarily stop operating.
• EyeSight may not recognize low-contrast objects, those with regularly spaced patterns,
no pattern, horizontal lines, backlit objects, very small objects (less than 3 feet tall) or
non-standard shaped vehicles, such as cement mixers or car-carrier trucks.
• Non-approved aftermarket vehicle accessories, such as hood protectors, and water-
repellent glass coatings should not be used with EyeSight-equipped vehicles. EyeSight
may not operate properly or EyeSight may temporarily stop operating.
*Please refer to the disclaimer information on the back cover.
Stereo Cameras Precautions
1989986_16a_Eyesight_WRX_STi_QRG_031915.indd 1 3/19/15 9:42 AM

Standard
There must be no oil lm, dirt, scratch or fogging that obstructs the forward visibility of the
stereo camera.
Do not stick or attach aftermarket parts on the prohibited areas shown in gray on the
windshield and top of the dashboard.
Even outside the prohibited area, if the abnormal operation occurs due to the reection of the
light or the reection on the glass, change the adhering position or installation position.
• Application of stickers or antennas, installation of wide‐type mirror
– This will affect the visibility of the stereo camera, causing the function not to
operate correctly.
• Placement of navigation unit, ETC or other things on the dashboard
– These things may be reected on the windshield glass, affecting the recognition of the
stereo camera, thus causing the function not to operate correctly.
FRONT VIEW
Windshield Glass and Dashboard
(A) 300 mm (11.8 in)
(B) 120 mm (4.7 in)
(C) Ceramic area
(D) Prohibited area (in gray)
(E) 200 mm (7.9 in)
1989986_16a_Eyesight_WRX_STi_QRG_031915.indd 2 3/19/15 9:42 AM

MSA5B1615A
Issued May 2015
Printed in USA 05/15
EyeSight®is a driver assist system that may not operate optimally under all driving
conditions. The driver is always responsible for safe and attentive driving. System
effectiveness depends on many factors such as vehicle maintenance, tire condition, and
weather and road conditions. See the Owner’s Manual for complete details on system
operation and limitations.
All information contained within this EyeSight®Quick Reference Guide was accurate at
the time of publication. Subaru of America, Inc. reserves the right to change features,
operation and/or functionality of any vehicle specification at any time without incurring any
obligation to make the same or similar changes to products previously sold. Your Subaru
retailer is the best source for the most current information. For detailed operating and
safety information, please consult your Owner’s Manual.
1989986_16a_Eyesight_WRX_STi_QRG_031915.indd 3 3/19/15 9:42 AM

Quick Reference Guide
WRX
2016
Love. It’s what makes a Subaru, a Subaru.
1989986_16a_Eyesight_WRX_STi_QRG_031915.indd 4 3/19/15 9:42 AM

EyeSight Functions
Pre-Collision Braking System
This function can recognize an impending collision with a vehicle or obstacle in front of
the EyeSight vehicle, alert the driver and even automatically apply the brakes to help avoid
a collision or minimize the impact when a collision is inevitable.
Pre-Collision Brake Assist
If EyeSight recognizes an impending collision with a vehicle or obstacle in front of the
EyeSight vehicle, and the driver is applying the brakes but not with enough brake pedal force,
Pre-Collision Brake Assist automatically applies up to full braking pressure in order to try to
shorten braking distance.
Pre-Collision Throttle Management
This function is designed to help prevent drivers from unintentionally accelerating into a
stopped vehicle or other obstacle in front of them. It simultaneously warns the driver and
reduces engine power until the driver applies the brakes to help avoid an impact.
Pre-Collision Throttle Management is helpful when:
• The driver inadvertently selects Drive instead of Reverse and starts to accelerate toward a
parked car, wall or parking structure.
• Starting to merge onto another road when the vehicle ahead accelerates, but suddenly stops.
Lane Departure Warning and Lane Sway Warning
Lane Departure Warning alerts drivers when they unintentionally move out of their travel lane.
It takes no corrective vehicle action other than issuing visual and audible warnings.
Lane Sway Warning acts in a similar way, detecting unusual back and forth vehicle movement
within the driver’s lane of travel that is usually indicative of a drowsy driver.
Adaptive Cruise Control and Lead Vehicle Start Alert
This function combines the benets of Cruise Control with active monitoring of the road
ahead by EyeSight. It issues warnings and activates automatic braking when needed.
Adaptive Cruise Control can regulate vehicle speed in order to keep a safe following distance
from the vehicle ahead. It does not replace Conventional Cruise Control, which can still be
used when desired. Lead Vehicle Start Alert noties the driver when the vehicle in front has
started moving but the EyeSight driver’s vehicle has not.
What is EyeSight?
EyeSight is a driving support system that uses a range of functions to assist the driver in
making decisions in order to provide for more safe and comfortable driving and to reduce
driver fatigue. It is designed to help assist drivers, not replace them.
How Does EyeSight Work?
EyeSight uses stereo cameras to process stereo images and identify objects such as the
vehicle in front, obstacles, trafc lanes and other items. Under the right circumstances,
EyeSight will apply the brakes or decrease the throttle to help reduce the severity of, or help
avoid a collision.
1989986_16a_Eyesight_WRX_STi_QRG_031915.indd 5 3/19/15 9:42 AM

INFO/SET switch
Steering Wheel Controls
INFO/SET switch
Use the arrows above and below to set or view information on various functions in the
multi-information display.
Cruise Control switch
Press to turn Adaptive Cruise Control on or off.
RES/+ switch
Press to resume set speed or to increase set speed while in either Adaptive or
Conventional Cruise Control.
SET/- switch
Press to set the current speed or to reduce set speed while in either Adaptive or
Conventional Cruise Control.
CANCEL switch
Press to cancel Adaptive Cruise Control or Conventional Cruise Control.
Following Distance Setting switch
• Press to change the following distance setting while using Adaptive Cruise Control.
• Press and hold to turn off Adaptive Cruise Control and to switch to Conventional
Cruise Control.
RES/+ switch
SET/– switch
CANCEL switch
Following Distance Setting switch
Cruise Control switch
1989986_16a_Eyesight_WRX_STi_QRG_031915.indd 6 3/19/15 9:42 AM

Lane Departure
Warning OFF light
Pre-Collision Braking
System OFF light
When these functions are off, the indicator light
on the instrument panel illuminates (see right).
Pre-Collision Braking
System OFF switch
Press and hold this switch to turn off
the Pre-Collision Braking System and
Pre-Collision Throttle Management.
Press and hold the button again
to turn the systems back on.
Lane Departure
Warning OFF switch
Press and hold this switch to turn
off the Lane Departure Warning and
the Lane Sway Warning functions.
Press and hold the button again
to turn the functions back on.
Lane Departure Warning and
Pre-Collision Braking System
OFF Switches
1989986_16a_Eyesight_WRX_STi_QRG_031915.indd 7 3/19/15 9:42 AM

Stereo camera Stereo camera
Location of Stereo Cameras
1989986_16a_Eyesight_WRX_STi_QRG_031915.indd 8 3/19/15 9:42 AM