Sunjoy S-AW054PST-A User manual

Sunjoy S-AW054PST-A 14' X 10' Marquise Full-Cassette Motorized
Retractable Awning – Green
Owner’s Manual
IMPORTANT
Thank you very much for choosing Sunjoy Group.
Please take time to read these instructions thoroughly and follow each step carefully for safe and easy
operation. Keep this manual for future reference.
We would like to hear from you with any comments or suggestions. You can call us toll-free at
1-866-578-6569 from 8:00 a.m. EST to 8:00 p.m. PST. You can also send the email to
[email protected] or visit www.sunjoyonline.com to get tech. assistance or to place your
replacement part order form.

Cautions:
1. Keep all children and pets away from assembly area. Children and pets should be supervised when they are
in the area of gazebo construction.
2. For your safety, Do not assemble this item alone. Two people are recommended for safe assembly.
3. Some parts may contain sharp edges. Wear protective gloves if necessary during assembly.
4. When assembling and using this product, basic safety precautions should always be followed to reduce the
risk of personal injury and damage to equipment. Please read all instructions before assembly and use.
5. For outdoor use only. This product should not be used with wind over scale 5 (29-38km/h)
This product is to be used only for shade purposes, do not use to shelter from bad weather.
6. Please close this product in bad weather, medium to high winds, heavy rain or snow. Do not use in cold
weather, may damage or affect product performance.
7. Check all bolts for tightness before and during usage
8. Warranty does not cover damage due to extreme weather conditions.
9. Do not use candles, matches or open flames of any kind in or near.
10. WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent is made
with fabric that meets CPAI-84 specifications for flame resistance. It is not fire proof. The fabric will burn if left in
continuous contact with any flame source.
11. The Motor can continue to work for three minutes.
If your motor works longer than three minutes, it will not work. But don’t worry,
which to continue work after 10-15 minutes resting.
The total cooling time of motor is 4-5 hours.
Assembly Instructions:
Our clear, easy-to-follow, step-by-step instructions will guide you through the project from start to finish. The
final product will be a quality piece that will go together smoothly and give years of enjoyment.
All you will need is a screwdriver, Wrench (M8, M12), a hammer and two (not included).
Parts identification: For ease of identification, all parts are labeled to correspond to the Step number in which
the part is use

Step 1: Installation of Wall Bracket
NO. Description Qty Image
A Awning 1
B Wall Bracket 3
C Link Part 3
D Crank Handle 1
E Remote Control 1
F Gear-bar 1
AA M8x20 Bolt 6
CC M10x90 Anchor Bolt 12
DD M12x60 Hex Sharp Bolt 12
Parts List
Notice:
Please call a professional for assistance on installation for walls other than wood or concrete.
Step.1: Open packaging, remove Wall Bracket (B), and anchor bolt (CC), to install on wall or ceiling. Place
anchors bolt (CC) or Hex Sharp bolt (DD) into the holes, install the wall bracket and keep all brackets level, and
tightly fasten screws. Each between distances is 2115mm
B
CC
Concrete
Wall
B
DD
Wood Wall
Fig.1

Step 2: Installation of Awning
Step 3: Awning Operation
Fig.1: Fabric Cover
Fig.2: Open and close manual-operated awning
Method 1: We recommend you to choose Remote Control (E) to Open and Close Awning,as Fig.3 to
show the buttons function.
Method 2:
Certainly, you also can use handle-way to open and close Awing.
Put the crank handle into gear box loop, Place hands on plastic handle and turn handle clockwise to open awning.
Step.2: Suggest two people lift the awning (A)
to the height of wall bracket, and slide the
awning (A) into wall bracket (B), connect Wall
Bracket (B) and Link Part (C) on Awning (A),
each between distances is 2115mm, as Fig.2.
Close
Stop
O
p
en
LED
Fi
g
. 3
Wall Bracket
Fig.2
Correctwa
y
Wrong way

Fig.2: Assemble Hook of crank Handle
When you use Crank Handle (D) to open and close Awning, you need assemble Hook of Crank Handle (F).
Insert Hook of Crank Handle (F) into the hole of Awning (A), and then to pull this hook, keep not fall off to
be well, as Fig.3
Step 4: Adjust Angle of Awning
Instructionforthefrontsideleveling
1. Loosen the Locking Nuts.
2. Turn the Jack Bolt to adjust Pitch.
3. Adjust the Arm until the front side is level.
4. Tighten the Locking Nuts.
Notice:
1. The cover need to remain tight when the awning is fully open
2. When turning the crank handle, make sure it keeps in the same straight line with loop
Correct way Wrong way
Plastic Handle

Care & Maintenance:
Our steel components for garden accessories and furniture are treated with rust inhibiting paint that protects it from
rusting. However, due to the nature of steel, surface oxidation (rusting) will occur once these protective coatings
are scratched. This is not a defect and thus not covered by the warranty.
To minimize this condition, we recommend care when assembling & handling the product to prevent scratching the
paint. Should any scratching or damage occur, we recommend immediate touch-up with rust inhibiting paint.
Surface rust can also be easily removed with a very light application of common cooking oil. If surface oxidation
(rusting) occurs and if no measure is taken to prevent this, the oxidation may start dripping on to deck or patio and
caused damaging stains, which may be difficult to remove. This can be prevented if the above-mentioned
measures are taken to keep the product from oxidizing.
Limited Manufacturer’s Warranty:
This limited warranty is extended to the original purchaser and applies to defects in materials and workmanship of
your item provided the item is maintained with care and used only for personal, residential purposes.
The item is warranted to be free from defects in material or workmanship for a period of One (1) Year. We
don't reimburse for transportation or delivery costs, or compensate the individual or any outside party for
assembling or disassembling the product.
Exclusions:
Items used for commercial, contract, or other non-residential purposes, or items damaged due to acts of nature,
vandalism, misuse, or improper assembly are not covered. Corrosion or rusting of hardware is not covered. Proof
of purchase (dated register receipt) is required for warranty claims. Warranty is to the original purchaser and is
non-transferable. Any replacement of warranted items will be in the original style and color, or a similar style and
color if the original is unavailable or has been discontinued. As some states do not allow exclusions or limitations
on an implied warranty, the above exclusions and limitations may not apply. This warranty gives you specific rights,
and you may also have other rights, which vary from state to state.
Made in China