ENG
3
Operation Manual MS-940
Fig. 2. Subwoofer bottom panel
Fig. 1. Subwoofer front view
c
a
b
d
BASS
+
–
TREBLE –
+
VOLUME
+
–
POWER
f
e
g
i
h
Subwoofer front view
aVOLUME: master volume control knob
bPower LED
cTREBLE: treble level control wheel
dBASS: subwoofer volume control wheel
eWoofer
Subwoofer bottom panel
fOUTPUT: speaker output
gINPUT: audio source input
hPOWER ON/OFF: power switch
iPower cord
5. PREPARATION AND OPERATION
Speaker placement
• Place speakers symmetrically to the listener at
the distance not less than one meter. Subwoofer
emits non-directional sound, therefore it can be
located in any place of the room, where it will sound
to the best advantage.
• Place MSS far away from monitors and TV sets,
as insigniԛcant image distortion in these supersen-
sitive devices is possible.
Installation and operation
MS-940 Multimedia Speaker System can be con-
nected to virtually any audio source: DVD/CD, PC
sound card, etc. (see Fig. 3).
Note! Before connecting, make sure that the
device is unplugged.
• Connect audio cable built-in speakers into OUTPUT
fof subwoofer bottom panel, as shown in Fig. 3.
• Insert mini-jack of signal cable (included) into
subwoofer INPUT gand opposite mini-jack of
signal cable connect into LINE OUT port of PC sound
card or OUTPUT of ǀDŽ3/CD-player (see Fig. 3). To
connect MSS to DVD-player or TV use stereo signal
cable mini-jack to 2RCA (not included) or adapter
mini-jack to 2RCA (not included) with stereo signal
cable mini-jack to mini-jack (included).
• Insert plug of power cord ion the bǢttom panel
of subwoofer into the socket (see Fig. 2).
•Adjust master volume level to its minimum by
turning master volume control VOLUME acoun-
terclockwise until it stops.