Swede Electronics ECB-401 User manual

TECHNICAL SPECIFICATIONS
Type no: ECB-401 ECB-601 ECB-801 ECB-1001
Rated current/voltage 4 A 24 V 6 A 24 V 8 A 24 V 10 A 24 V
Battery voltage/size 24 V, 12 cells
12 to 40 Ah* (C5)
24 V, 12 cells
18 to 60 Ah* (C5)
24 V, 12 cells
25 to 80 Ah* (C5)
24 V, 12 cells
32 to 100 Ah* (C5)
Mains voltage 230 V~ 50 Hz 230 V~ 50 Hz 230 V~ 50 Hz 230 V~ 50 Hz
Max power consumption
200 VA 295 VA 290 VA 600 VA
Mains current (max effect) 0,9 A 1,3 A 1,7 A 2,6 A
Weight 1,3 kg
Measurements (H x W x D)
205 x 179 x 90 mm incl. handle
Casing class IP44
Insulation class II (double insulated)
Safety class Type B
* EC-buddy is capable of charging batteries up to maximum battery size to 80% in less than 8 hours. The
charger can be used for both GEL- and AGM batteries.
EC-buddy features protection for:
- Reversed polarity
- Shortening of cables
- Sparks when connecting to power or battery
- Overheating
The battery charger should not be exposed to direct sun light
The battery charger may not, completely or partly be, lowered into water or covered with snow.
Cables and connectors may only be replaced by the manufacturer or an authorized service workshop.
CE-markings:
The manufacturer hereby assures that the ECB-1001 complies with the following standards:
EN 60601-1, EN 60601-1-2, EN 12184, ISO 7176-14
Manufacturer:
Swede Electronics i Nås AB
Hjärpholn 18
SE-780 53 NÅS, Sweden
Phone: [phone]
Fax: [phone]
www.swedeelec.se
[email protected]
User manual
for
EC-buddy

INSTRUCTIONS FOR USE
1
Connect the battery chargers power cord
to the socket.
2
Connect the charging connector to the
battery.
1
Power cord and charging connector can
be connected in any order.
1
See the manual of the vehicle for location of the
charging socket.
3
Green light flashes during charging
process.
The battery charger will be warm during the charging
process. This is completely normal. The battery
charger is equipped with protection for overheating.
4
Green light is lit when the charging is
completed and the battery is ready for
use.
As the charger uses very little current and cannot
overcharge the battery, it can be left connected to the
battery until the vehicle is required for use.
5
Disconnect the charging connector from
the battery
1
before using the vehicle.
1
See the manual of the vehicle for location of the
charging socket.
6
The power cord may be disconnected.
WARNING
-Batteries emit explosive gases during charging. Avoid flames and sparks.
-The charger is intended only for lead batteries with 12 cells (24V).
-The charger is equipped with overheating protection but can become hot during charging.
-Charging must be done in a place with good ventilation.
-If one of the connectors becomes hot during operation, this can be an indication that the connector is worn
or damaged. In such cases both the male and female connectors should be replaced.
Cables and connectors must be changed only by the manufacturer or by an authorised service workshop.
INDICATIONS
Indication Significance/ Cause Action
Steady blue light
= Connected to power
Flashing green light
= Charging in progress
Steady green light
= Charging completed The battery charger may stay
connected until the vehicle will
be used
Steady red light
= Battery cables are
connected to the wrong
poles, i.e. reverse
polarity
Please contact your service
partner
Flashing
= Battery error Please contact your service
partner
Flashing and sounding
= Charging disrupted/not
completed The charger should be connected until the vehicle will
be used or until the charging is
completed
In case faults cannot be corrected, please contact an authorized service workshop.
CARE AND MAINTENANCE
•Each time before using the charger, check that the cables and connectors are not damaged
or worn. If this is the case, the cable/connector must be replaced immediately by the
manufacturer or by an authorised service workshop.
•For the best results, economics, and service life of the charger, battery, and driving distance
per charging, the following advice should be followed:
-The charger, connectors, and batteries must be kept clean from dirt, dust, and oxide.
-Switch off the vehicle when it is not in use.
-Charge the battery daily, or as soon as possible when it is empty.
-Use the charger to trickle charge the battery when the vehicle is in storage for a longer
period.
2
•The charger can be cleaned as required using a moist piece of rag.
2
As the charger does not use much current and cannot over-charge the battery, it can be
beneficial to connect it to charge the battery until the vehicle is to be used.