Symmons Dia 352SH Series Manual

Dia®
Model Number Specification
Modifications
Dimensions
Note: Dimensions subject to change without notice.
Compliance
Warranty
Limited Lifetime - to the original end purchaser in
consumer installations.
5 Years - for commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.Note: Append appropriate -sufx to model number.
AA
BB
DD
CC
352SH
352SH-3
352SH, 352SH-3
Showerhead Series
Operation & Maintenance Manual
☐352SH 1 Mode Showerhead
☐352SH-3 3 Mode Showerhead
☐-1.5 1.5 gpm (5.7 L/min) flow restrictor
☐-2.0 2.0 gpm (7.6 L/min) flow restrictor
• 1 mode showerhead (352SH)
• 3 mode showerhead (352SH-3)
• 3" diameter
• Easy to clean rubber nozzles
• 2.5 gpm (9.5 L/min) standard ow restrictor
CG
- ASME A112.18.1/CSA B125.1
- WaterSense 1.5 gpm, 2.0 gpm
Measurements
A 4-1/4", 108 mm
B 4-1/8", 105 mm
C 4-3/4", 121 mm
D 4-1/2", 114 mm
Certied by
CSA Group

Symmons Industries, Inc. ■31 Brooks Drive ■Braintree, MA 02184 ■Phone: [phone] ■ Fax: [phone]
Copyright © 2018 Symmons Industries, Inc. ■symmons.com ■[email protected] ■ZV-3046 REV C ■ 032018
1) Install showerhead to shower arm (not included)
turning clockwise to tighten.
1
2
Installation
Tools Required for Installation
Plumber Tape
Operation
1) Turn showerhead to desired mode of operation.
Troubleshooting Chart
Problem Cause Solution
Finish is spotting. Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then quickly
rinse with water.
Showerhead is leaking from shower
arm when valve is in "on" position.
Coupling connecting showerhead to
shower arm is cracked.
Inspect coupling and replace
showerhead if necessary.