System Equine Horse Stock Series User manual

System Fencing Limited 1of 7 Run-In Shed Instructions
July 6/09 RevD
Horse Stock Series Instructions
1. With helper, stand end frames on its side on floor with the tabs facing outwards
2. Slide top cross beam support on floor into end frames
3. Locate end frame with holes near top (this is the front of the horse stock)
4. Attach Tie braces to the front nearest the floor of the stock using ½” x 3 ½” bolts
provided. Hand assemble on the floor

System Fencing Limited 2of 7 Run-In Shed Instructions
July 6/09 RevD
5. Hand assemble the top cross beam supports to back of frame with ½” x3” bolts
6. Repeat step 4 and 5 but on the top side of the stock
7. With helper stand Horse Stock up

System Fencing Limited 3of 7 Run-In Shed Instructions
July 6/09 RevD
8. Locate sides of stock and attach to desired height with pins provided
(ensure butt bar holes are toward the back)

System Fencing Limited 4of 7 Run-In Shed Instructions
July 6/09 RevD
9. Attach butt bar with ½” x 3 ½” bolts provided
10. Put doors on using 5/8” bolts provided

System Fencing Limited 5of 7 Run-In Shed Instructions
July 6/09 RevD

System Fencing Limited 6of 7 Run-In Shed Instructions
July 6/09 RevD
11. Cut a piece of wood to 32” to wedge inside of stock between the legs
12. Tighten up all bolts firmly
13. Using wedge anchors lag Horse Stock to the floor