TECshow MINI DERBY User manual

P. 1
Versión Español | Tecshow COSMO MAX
MINI DERBY
4 LEDS RGBW X 3W DERBY
USER MANUAL | MANUAL DE USUARIO
PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE USE
POR FAVOR LEA LAS INSTRUCCIONES ANTES DE USAR

P. 2
English Version | Tecshow MINI DERBY
MINI DERBY
4 LEDS RGBW DE 3W
MINI DERBY is an eect that provides the coverage
of classic derby in a compact format. It has 4
3W LEDs, with RGBW mix (1R, 1G, 1B, 1W). The
equipment incorporates an AUTO/OFF power
button on its rear panel and a knob to dimmer the
microphone sensitivity in its audiorhythmic mode.
Specifications
Source & Optics
• Light source: 4x 3W RGBW LEDs (lxR, lxG, lxB, lxW)
• Beam angle: 150º
• Average lifespan: 50,000 hours
Eects & Functions
• Derby eect
• Strobe eect
Control
• DMX Channels: 7
• Operation modes: Auto & Audiorhythmic
• Remote control included
Physical
• Weight: 0.9 kg
• Dimensions: 110x100x155 mm.
1· OVERVIEW

P. 3
English Version | Tecshow MINI DERBY
• Please keep this User Manual for future reference.
If you sell the unit to another user, be sure that he
also receives this instruction booklet.
• Unpack and check the unit carefully that it has
not been damaged during transport before using
the unit.
• Before operating, ensure that the voltage and
frequency of power supply match the power
requirements of the unit.
• It’s important to ground the yellow/green
conductor to earth in order to avoid electric shock.
• The unit is for indoor use only in a dry location.
• The unit must be installed in a location with
adequate ventilation, at least lm from adjacent
surfaces. Be sure that no ventilation slots are
blocked.
For your own personal safety, please
read and understand this manual
completely before you attempt to
install or operate this unit!
2. SAFETY INSTRUCTIONS
• Disconnect mains power before fuse replacement
or servicing.
• Replace fuse only with the same type.
• Make sure there are no inammable materials
close to the unit during operation.
• Use safety cable when xing this unit.
• In the event of serious operating problem, stop
using the unit immediately.
• Never try to repair the unit by yourself. Repair
carried out by unskilled people can lead to
damage or malfunction.
• Please contact the nearest authorized technical
assistance center and always use the same type
of spare parts.
• Do not touch any wires during operation as high
voltage might be causing electric shock.
• The external exible cable or cord of this
luminaire cannot be replaced; if the cord is
damaged, the luminaire shall be destroyed.
• The product is for decorative purposes only and
not suitable as a household room illumination.
CAUTION! DISCONNECT DEVICE.
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device
shall remain readily operable.
The unit should be mounted via its screw holes on the
bracket. Always ensure that the unit is rmly xed to
avoid vibration and slipping while operating. Always
ensure that the structure to which you are attaching
the unit is secure and able to support a weight of 10
times of the unit’s weight. Also always use a safety
cable that can hold 12 times the weight of the unit
when installing the xture.
The equipment must be xed by professionals at a
place where is out of the reach of people and where
nobody can pass by or under it.
3. INSTALATION

P. 4
English Version | Tecshow MINI DERBY
4. OPERATION
The unit can work either automatically or follow the
rhythm of the music via the built-in microphone on
the rear panel.
Plug the unit into an appropriate mains outlet that
supplies the required voltage for the unit and it will
start working.
A. AUTO MODE
Set the switch on the rear panel to AUTO position.
The unit will run automatically.
B. SOUND-CONTROLLED MODE
The unit will work to the rhythm of the music. You
can set the sensitivity of the microphone via the
SENSITIVITY knob.
5. FIXTURE CLEANING
The cleaning of internal and external optical lenses
and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends
on the environment in which the xture operates:
damp, smoky or particularly dirty surrounding can
cause greater accumulation of dirt on the unit’s optics.
• Clean with so cloth using normal glass cleaning uid.
• Always dry the parts carefully.
• Clean the external optics at least every 20 days.
• Clean the internal optics at least every 30/60 days.
IMPORTANT NOTE!
Electric products must not be put into household waste. Please bring them to a recycling centre.
Ask your local authorities or your dealer about the way to proceed.

amproweb.com
/amprogroup /amprogroup