Televes 106501 User manual

MATV
Antenna / Antena
Ref. 106501
BIII
High VHF
1
3
5
2
4
6
9/32”
(7mm)
1/8”
(3mm)
CLICK!
x5
REFLECTOR

2016 © Copyright, Televés S.A.
Reference Referencia 106501
Working
band
Banda de
trabajo MHz
174 - 230
CH 05 - 12 (EU)
CH 07 - 13 (USA)
Gain Ganancia dBi 9.5
F/B ratio Relación D/A dB 20
Dimensions Dimensiones mm
in
1410 x 900 x 105
55.51” x 35.43” x 4.13”
Wind load Carga al
viento N71 (1)
97.7 (2)
(1) 80 miles/h - 130 Km/h
(2) 93 miles/h - 150 Km/h
ANSI/CEA-2028-A
Safety Instructions:
LIGHTNING PROTECTION
If installed outdoors, be sure the antenna system is grounded
so as to provide protection against voltage surges and built-
up static charges. Section 810 of the National Electrical Code
ANSI/NFPA70, or CSA C22.1 sections 10, 16, and 54, of the
Canadian Electrical Code, provide information with respect
to proper grounding of the mast and supporting structure,
grounding of the antenna lead-in wire to an antenna
discharge unit, size of grounding conductors, location
of antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode
(see gure and instructions).
Mount the lightning arrestor or 75 ohm coaxial grounding
block as close as possible to where the 75 ohm coaxial cable
downlead enters the house.
The ground wires for both the mast and the downlead should
be copper or aluminum wire, number eight (8) or larger.
The downlead wire from the antenna to the lightning arrestor
and the mast ground wire should be secured to the house,
spaced from four (4) to six (6) feet apart.
In the case of a “ground up” antenna installation it may not
be necessary to ground the mast if the mast extends four
or more feet in the earth. Consult a TV serviceman for the
proper depth in your location.
WARNINGS
To prevent re or shock hazard, do not expose the included
power supply to rain or moisture.
Installation of o-air antennas near power lines is dangerous.
For your safety, follow the installation instructions.
Any alteration or modication to the product or usage not
in accordance with product instructions voids the warranty.
Antenna Lead
in Wire
Example of antenna grounding as per
National Electrical Code, ANSI/NFPA 70
NEC - National Electrical Code
Ground
clamp
Electric Service
Equipment
Ground clamps
Power service Grounding Electrode System
(NEC Art 250, Part H)
Antenna Discharge Unit
(NEC Section 810-20)
(May substitute a 75 ohm
Coax Grounding Block)
Grounding Conductors
(NEC Section 810-21)
DECLARACIÓN DE CONFORMIDAD DECLARATION OF CONFORMITY DECLARAÇÃO DE CONFORMIDADE DECLARATION DE
CONFORMITE DICHIARAZIONE DI CONFORMITÀ DEKLARACJA ZGODNOŚCI KONFORMITÄTSERKLÄRUNG ΠΙΣΤΟΠΟΙΗΤΙΚΟ
ΣΥΜΜΟΡΦΩΣΗΣ FÖRSÄKRAN OM ÖVERENSSTÄMMELSE ДЕКЛАРАЦИЯ СООТВЕТСТВИЯ https://doc.televes.com