Televes V Zenit 149381 User manual

MATV
Antenna / Antena
Ref. 149381 (Ant-149321+ P)
A B
H x2
D
C x2
J x2
O x2
N x2
G x2
F x2
L
K x4
E
M
I
1
5
2
7
4 6
A
D
C
CB
K
K
F
G
N
L
O
3
21
2
8
CLIC!
H
H
10 mm
P

2016 © Copyright, Televés S.A.
14
16 1715 CLIC!
I
109 11
CLIC!
CLIC!
12 13
G
E
J
J
N
F
K
M
9/32”
(7mm) 1/8” (3mm)
Ref. Ref. 149381
Working
band Banda de trabajo MHz High VHF
UHF 174 ... 216 (CH07-13) 470 ... 698 (CH14-51)
Gain Ganancia dBi High VHF
UHF 8,5
13
F/B ratio Relación
D/A dB High VHF UHF > 12 > 23
Wind
load Carga al viento N96 (1)
132 (2)
(1) 80 miles/h - 130 Km/h (2) 93 miles/h - 150 Km/h
High VHF / UHF
Safety Instructions:
LIGHTNING PROTECTION
If installed outdoors, be sure the antenna system is grounded so
as to provide protection against voltage surges and built-up static
charges. Section 810 of the National Electrical Code ANSI/NFPA70, or
CSA C22.1 sections 10, 16, and 54, of the Canadian Electrical Code,
provide information with respect to proper grounding of the mast
and supporting structure, grounding of the antenna lead-in wire to
an antenna discharge unit, size of grounding conductors, location
of antenna-discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode (see gure and instructions).
Mount the lightning arrestor or 75 ohm coaxial grounding block as
close as possible to where the 75 ohm coaxial cable downlead enters
the house.
The ground wires for both the mast and the downlead should be copper
or aluminum wire, number eight (8) or larger.
The downlead wire from the antenna to the lightning arrestor and the
mast ground wire should be secured to the house, spaced from four (4)
to six (6) feet apart.
In the case of a “ground up”antenna installation it may not be necessary
to ground the mast if the mast extends four or more feet in the earth.
Consult aTV serviceman for the proper depth in your location.
WARNINGS
To prevent re or shock hazard, do not expose the included power
supply to rain or moisture.
Installation of o-air antennas near power lines is dangerous. For your
safety, follow the installation instructions.
Any alteration or modication to the product or usage not in accordance
with product instructions voids the warranty.
Antenna Lead
in Wire
Example of antenna grounding as per
National Electrical Code, ANSI/NFPA 70
NEC - National Electrical Code
Ground
clamp
Electric Service
Equipment
Ground clamps
Power service Grounding Electrode System
(NEC Art 250, Part H)
Antenna Discharge Unit
(NEC Section 810-20)
(May substitute a 75 ohm
Coax Grounding Block)
Grounding Conductors
(NEC Section 810-21)
Televes USA LLC 425 South Cherry Street, Suite 635 Denver, CO 80246 www.televes-usa.com [e-mail] www.televes.com
DECLARACIÓN DE CONFORMIDAD DECLARATION
OF CONFORMITY DECLARAÇÃO DE
CONFORMIDADE DECLARATION DE CONFORMITE
DICHIARAZIONE DI CONFORMITÀ DEKLARACJA
ZGODNOŚCI KONFORMITÄTSERKLÄRUNG
ΠΙΣΤΟΠΟΙΗΤΙΚΟ ΣΥΜΜΟΡΦΩΣΗΣ FÖRSÄKRAN
OM ÖVERENSSTÄMMELSE ДЕКЛАРАЦИЯ
СООТВЕТСТВИЯ بيان المطابقة
https://doc.televes.com