Telit Wireless Solutions WE310F5-I User manual

Telit Technical Documentation
WE310F5-I/P
Quick Setup Guide
1. Connect the micro-USB UART1 port to your system.
2. Change the toggle switch position to Program.
3. Download and unzip the Telit_Wifi_Image_Tool.
For download information, see Resource Links.
4. Open the Telit_Wifi_Image_Tool folder.
5. Open the Telit_Wifi_Image_Tool application.
6. Click Browse.
7. Navigate to the Telit_Wifi_Image_Tool and select s2w.bin file.
8. To initiate the flash, click Program.
9. After the flash process is complete, click OK.
10. Close the Telit_Wifi_Image_Tool.
The WE310F5 EVB is ready to configure.
Program the WE310F5 Module
1. Connect the micro-USB cable to the UART0 port.
2. Change the toggle switch position to Run.
3. Open Tera Term > Setup > Serial Port.
4. Set the BAUD rate.
The WE310F5 EVB is ready to use.
Configure the WE310F5 Module
Wireless Mode-Station Mode
1. To set the module in Station Mode: AT+WNI=0.
2. To connect the network to L3:
3.
Wireless Mode-AP Mode
1. To set the module in AP Mode: AT+WNI=1.
2. To configure the IP:
3. To configure the node in AP Mode:
Prerequisites:
•Ensure to connect the module and the node to the same WPA2
Secured Wi-Fi network.
•Insert the SIM card in the appropriate SIM card slot.
Bluetooth Mode-Station Mode
1. To scan the available Bluetooth devices: AT+BI=1.
2. For DUT peripheral connection:
Device 1
AT&W0
AT+YSR
AT+BI=1
AT+BICAP=0
AT+BADVINTMIN=60
AT+BADVINTMAX=60
AT+BADVE=1
AT+BATTRIB="pserv","uuid=1234"
AT+BATTRIB="char","prop=0x0c","uuid=5678"
AT+BATTRIB="charval","perm=0011","len=1","val=0x30"
AT+BATTRIB="complete"
AT+BOAD
AT+BI=1
AT+BCONINTMAX=1000
AT+BCONINTMIN=1000
AT+BCONNECT="00217E368'22","t2"
AT+WNAPIPC=0,192.168.5.3,192.168.5.20,86400000
AT+WNIPC=0,1,192.168.5.1,255.255.255.0,192.168.5.1
AT+WNCN=1,"Telit_WiFi",“Password123",11
1VV0301671 Rev. 7 –2021 -07 -16

WE310F5 Products
Copyright © 2021 Telit. All rights reserved.
W
-
I
WE310F5-I Antenna Connector
10
ARDUINO Enable (PL705)
W
-
P
WE310F5-P RF Pad
11
UART1
1UART (PL608)
12
GPIO-LED (PL606)
2I2S-I2C (PL601)
13
UART0
3GPIO – Alternate Function
(PL302 –PL305)
14
Power Switch-EVB
4General Purpose Button (PB1-PB2)
15
Power connector USB 2.0
5Reset Button
16
Power Config (PL201-P204)
6RUN/ PROGRAM Toggle Switch
17
SWD
7Audio Jack
18
SPI-SDIO (PL604)
8Power Switch-Module
19
LED
9PB1-PB2 (PL605)
WE310F5-I
WE310F5-P
WE310F5 CalIouts
Resource Links:
•Telit_Wifi_Image_Tool –
https://www.telit.com/wp-content/uploads/2021/01/Telit_WE310F5_
39.00.000-B017.zip
•For more information, visit
https://www.telit.com/products/wifi-and-bluetooth/#wifi
•For technical support, email us at TS-[email protected]
•For a video demonstration, see https://www.telit.com/developer-
zone/we310f5-i-p-evb/?