TEMPLE & WEBSTER GLCBAA User manual

ASSEMBLY INSTRUCTIONS
GLCBAA
Read these instructions and follow steps carefully to ensure you assemble the
product correctly and avoid damages. Check that all parts and
hardware have been provided before assembling the product. Place all
contents on a clean, soft-flat surface to avoid scratching the product.
CAUTION:
Only tighten bolts to 80% at first. Once all parts have been assembled, fully tighten all
hardware.
To prevent damage to threads, do not use a power tool and do not overtighten bolts.
Use two people to lift and turn the product when assembling.
Do not attempt with only one person and do not roll onto legs.
Keep all hardware and small parts away from children.
PART LIST HARDWARE LIST
ITEM DESCRIPTION QTY ITEM DESCRIPTION QTY
A
2B
STEP 1: Attach both leg (B) to base (C). Install washers (2) and lock nuts (3) on each bolt of
the legs as shown below. Use wrench (6) to secure.
1PC
BASE
4PCS
STEP 2: Attach back (A) to base (C). Insert nuts (1) into base (C). Then insert bolt (1)
through back (A) into base (C) as shown below. Tighten with allen key (7).
C1PC
BACK
5
WASHERS
3
416PCS
2PCS
ALLEN KEY
BRACKET 4PCS
SCREW M4X15
1PCSCREWDRIVER
2
1
7
8
2PCS
LEG 2PC
C
BOLT M6X120
34PCS
LOCK NUT
1PC
KEY
6
BASE CUSHION
D1PC
E1PC
BACK CUSHION
B
6C
A
7
1
NUT

ASSEMBLY INSTRUCTIONS
GLCBAA
Read these instructions and follow steps carefully to ensure you assemble the
product correctly and avoid damages. Check that all parts and
hardware have been provided before assembling the product. Place all
contents on a clean, soft-flat surface to avoid scratching the product.
CAUTION:
Only tighten bolts to 80% at first. Once all parts have been assembled, fully tighten all
hardware.
To prevent damage to threads, do not use a power tool and do not overtighten bolts.
Use two people to lift and turn the product when assembling.
Do not attempt with only one person and do not roll onto legs.
Keep all hardware and small parts away from children.
STEP 3: Insert bracket (5) into back (A) & base (C). Then insert screws (4) through bracket
(5) into back (A) & base (C) as shown below. Tighten with screwdriver (8).
STEP 4: Place the assembled chair upright on a level surface. Ensure all chair legs are
aligned & level, then fully tighten all bolts & screw using allen key (7). Your chair is now
ready for use.
8
4
PART LIST HARDWARE LIST
ITEM DESCRIPTION QTY ITEM DESCRIPTION QTY
A
2B
1PC
BASE
4PCS
C1PC
BACK
5
416PCS
2PCS
4PCS
1PC
BOLT M6X120
WASHERS
LOCK NUT
SCREW M4X15
BRACKET
KEY
ALLEN KEY
SCREWDRIVER
1
7
8
2PCS
LEG 2PC
34PCS
1PC
6
BASE CUSHION
D1PC
E1PC
BACK CUSHION
5
C
A