TERMA MEG User manual
PLEN DE FR ITCS SKRU
User Manual
Electric Heang Element
MEG · DRY · MOA ·
MOA IR · REG 2 · REG 3
3
EN
User Manual
Our products have been designed and manufactured in such a way to ensure
that all quality, functionality and aesthetic requirements are met. We would
like to congratulate you on the purchase of this great product and wish you
a pleasant experience with it.
Electric radiator
Guide to safe installation anduse.
1. Do not install the heater under an electrical socket point.
2. Your electric heater should be lled with a carefully measured amount of
liquid. In the case of loss of heating medium, or in any other case which
demands its supplementation, contact your supplier.
3. The device is not equipped with an external temperature controller *).
Do not use the device in a small room if unsupervised disabled or inca-
pacitated individuals are inside it. Only use the device if those individu-
als are under constant supervision.
*) Does not apply to selected models. Ask your supplier for details.
4User manual MEG, DRY, MOA, REG 2, REG 3
4. Electric heater is not a toy. Children under the age of 3 should not be al-
lowed within close proximity of the device without the supervision of an
adult.
Children aged 3 to 8 should only be allowed to operate the heater when
it has been properly installed and connected. The child must be under
adult supervision or have been trained to safely operate the device while
understanding the risks.
5. Note: Some parts of the radiator can be very hot and can cause burns. Pay
special attention to the presence of children or people with disabilities.
6. If the device is used as a clothes and towel dryer, ensure that the fabrics
drying on it have only been washed in water, avoiding contact with any
harsh chemicals.
7. To ensure the safety of very small children, install the electric dryer so
that the lowest tube is at least 600mm above the oor.
8. The device should only be installed by a qualied installer in accordance
with the applicable regulations regarding safety and all other regulations.
9. All installations to which the device is connected should comply with reg-
ulations applicable in the country of installation and use.
10. Extension leads or electric plug adapters should not be used in order to
supply power to the heater.
5
EN
11. While connecting the radiator to electric installation ensure that the cur-
cuit has a 30 mA residual-current circuit breaker and an appropriate over-
current circuit breaker. With the permanent installation (cable connec-
tion without plug) it is also mandatory to provide an omnipolar cut-o
switch with a minimum contact opening of 3 mm for disconnecting the
device on all poles.
12. The device version labelled PB can be installed in bathrooms in zone 1,
as dened by applicable law, subject to any additional regulations con-
cerning electrical installations in wet areas.
Other versions of the device can be installed in Zone 2 or beyond.
13. The device is recommended for use solely as described in the manual.
14. Ensure that the heater has been installed on a wall in accordance with
its installation manual.
15. Please forward this instruction manual to the end user.
6User manual MEG, DRY, MOA, REG 2, REG 3
Zone 1
Zone 2
7
EN
Electric Heating Element
Safety requirements — installation
1. Fitting and connection of the heating element should only be performed
by a qualied installer.
2. Connect the unit to a sound electrical installation (see the ratings on the
heater).
3. Switching on the heating element in the open air to test the device is per-
mitted for a maximum of 3seconds.
4. Never test a heating element that is already in- stalled. Do not turn the
heating element on in an empty radiator!
5. Ensure that the power cord does not touch the hot parts of the heating
element or radiator.
6. Before installing or removing the device, make sure it is disconnected
from the power source.
7. Do not open the device — any interference with internal components
will invalidate the warranty.
8. The heating element’s power output must not exceed the radiators pow-
er output for the parameters 75/65/20° C.
8User manual MEG, DRY, MOA, REG 2, REG 3
9. The pressure in the radiator should not exceed 10atm. Ensure that an
air cushion is preserved in electric radiators. In central heating systems,
leave one valve open to prevent pressure build up due to the thermal
expansion of the liquid.
10. The device is intended for home use only.
11. Fitting and Installation of the device must be carried out in accordance
with all local regulations for electrical safety, including installation within
permissible locations only. Observe bathroom electrical zone regulations.
Safety requirements — use
1. The heating element must be fully submerged in the heating liquid dur-
ing its operation.
2. Regularly check the device for damage to ensure it is safe to use.
3. If the power cord is damaged the device should not be used. Unplug the
device and contact the manufacturer or distributor.
4. Do not allow ooding into the heating element casing.
5. Do not use the heating element in heating systems where the water tem-
perature exceeds 82° C.
9
EN
6. The heating element and radiator can heat up to high temperatures. Please
be cautious — avoid direct contact with the hot parts of the equipment.
7. Do not open the heating element casing.
8. In the central heating system, always make sure that one valve of the ra-
diator remains open.
9. Ensure that minors aged 8 and above or those with a physical or mental
disability are supervised if operating the device.
10. The device is not a toy. Keep it out of the reach of children.
11. The device must be disconnected from the mains during cleaning and
maintenance.
12. Cleaning of the equipment by children under 8years of age is only per-
mitted under appropriate supervision.
10 User manual MEG, DRY, MOA, REG 2, REG 3
Intended use of device
-
-
Technical informaon
Model markings
(power cable type):
Type of electrical connecon:
Heat outputs available:
Power supply:
Insulaon class:
Towel rail connecon thread:
Casing protecon class [IP]:
Length of heang element:
11
EN
Installaon or removal
-
-
-
150°
-
Before installaon or rst use:
Safety requirements
—Installaon.
-
-
-
-
-
-
(
12 User manual MEG, DRY, MOA, REG 2, REG 3
-
-
Notes prior to removal:
-
-
-
-
Product disposal
-
-
-
Maintenance
13
EN
MEG
-
-
-
-
Temperature increase
-
Temperature decrease
-
-
An-freeze funcon
(an-freeze protecon)
-
-
-
temperature regulaon
turn on / o buon
14 User manual MEG, DRY, MOA, REG 2, REG 3
Problem solving
-
-
15
EN
DRY
Funcons
-
-
-
-
-
Heater use
-
-
-
-
-
TIMER buon
TIMER indicaon
Indicaon of heater current
working state
On / o buon
16 User manual MEG, DRY, MOA, REG 2, REG 3
-
-
-
-
Modicaon of radiator heang
temperature
-
-
-
-
52°
55°
60°
48°
43°
17
EN
Device malfuncon alert
-
-
-
-
-
-
-
-
-
-
-
18 User manual MEG, DRY, MOA, REG 2, REG 3
Problem solving
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
19
EN
MOA
-
-
-
-
Temperature increase
-
-
-
Temperature decrease
-
-
-
An-freeze funcon
-
dryer funcon
turn on/o buon
temperature regulaon
20 User manual MEG, DRY, MOA, REG 2, REG 3
Dryer funcon
-
-
-
-
and
-
Calibrang the temperature span
-
-
and
Other manuals for MEG
1
This manual suits for next models
5
Table of contents
Languages:
Other TERMA Heater manuals
Popular Heater manuals by other brands
VOKERA
VOKERA ETV-10 Installation & servicing instructions
Twin-Star International
Twin-Star International duraflame 9HM8000 instruction manual
camry
camry CR 7721 user manual
Varma Tec
Varma Tec WR65 operating instructions
Oceanic
Oceanic HT10BJ user manual
Purmo
Purmo YALI PARADA PLUS Installation and operating manual
