Texas Instruments PGA309EVM User manual

PGA309EVM
Step-by-step example
Art Kay
9-22-2023

Set the jumpers on the test board.
JMP
Position
10
NC
11
Vdut
Power
12
Vexc
17
Emulate
14
10m
15
10m
16
Rt+
2
Vs
1
NC
3
ADS1
9
NC
4
Emulate
5
Emulate
13
Diode
6
Emulate
7
NC
8
ONE to PRG

Set the jumpers on the USB-DAQ
JMP
Position
17
BUS
13
Reg
14
9V
9
5V
11
WP On
6
5V
7
REF
1
EXT
8
GND
10
WP On
3
EE On
2
EXT
4
L
5
L
18
VDUT

Connect Power (6V to 9V) then USB
1. Connect 6V to 9V
DC power here
2. LED should
eliminate as shown.
3. Connect USB
here

Start Software
Should see a quick
update on status
bar and no error
messages.

Select the “4wire_4p096_diode.txt” if needed
This file should be
selected. If it is not, press
the “Select Model File
Emulator File” button and
choose the file.

Run Auto-Cal
1. Check “auto-
continue” to speed
up calibration.
2. Press start.
3. Continue should
start to blink. Press
this to initiate
calibration.

Calibration progress
1. Text describing
the current step is
shown here
2. Measured results will update
here. The sensor emulator will
automatically adjust the “sensor”
output according to the current
emulated temperature and
pressure.

Calibration complete
1. Notice that the calibrated
min and max output are
approximately at the target
of 0.5V to 4.5V. This
indicates that the calibration
worked and the hardware is
functioning correctly

Sensor emulator for verification
Press “run sensor emulator”
on the “Set up cal” tab. This
will bring up the tool on the
right. It will take a few
seconds for the data to load.