29
must be receive an store by the temperature station in the first minute of
power being supplie to it.
SETTING UP:
Note: This temperature station receives onl one outdoor transmitter.
1. First, insert the batteries into the out oor transmitter (see “Install and
replace batteries in the outdoor transmitter“).
2. Imme iately after an within 1 minute, insert the batteries into
temperature station (see “Install and replace batteries in the
temperature station”). Once the batteries are in place, all segments of
the LCD will light up briefly. Then the in oor temperature will be isplay.
If this is not isplaye after 60 secon s, remove the batteries an wait
for at least 10 secon s before reinserting them.
3. After inserting the batteries into the out oor transmitter, the temperature
station will start receiving ata from the out oor transmitter. The signal
reception icon flashes.
4. To toggle the isplay to the out oor temperature press the IN/OUT
button. The out oor temperature an the signal reception icon shoul
then be isplaye on the temperature station. If this oes not happen
