The Container Store Linea Leaning Desk User manual

Linea
Leaning
Desk
Assembly Instructions
Please read all of the information below before you begin.
Hardware
(H1) x 4+1 extra long dowel
(H2) x 4+1 extra short bolt
(H3) x 2+1 extra binding screw
(H4) x 2+1 extra long bolt
(H5) x 4+1 extra short dowel
(H6) x 2 Allen wrench
(H7) x 4+1 extra 1/2" pan head screw
(H8) x 6+1 extra 1" pan head screw
(H9) x 2 mending plate
(H10) x 4+1 extra flathead screw
(H11) x 1 left bracket
(H12) x 1 right bracket
(H13) x 1 38mm wall screw
(H14) x 1 wall anchor
(H15) x 1 pan thread screw
(H16) x 1 wall strap
(H1) (H3) (H4)
(H2)
(H5) (H6) (H7) (H8)
(H9) (H10)
Anti-Tip Hardware
(H13) (H14) (H15) (H16)
Thank you for purchasing the Linea Leaning Desk. The contents included in the box are
listed below and on the next page. Please take the time to identify the hardware and
desk components. As you unpack and prepare for assembly, place the contents on a
carpeted or padded surface to protect them from damage.
Required Assembly Tools
Hammer or
Mallet
Phillips Screwdriver
Drill &
17/64" Drill Bit
WARNING — Severe injury may occur if furniture tips over. Never allow children to climb or play on this product. Place heavier items on lower shelves
as far back as possible and never overload. Follow all instructions listed in this assembly guide and always use the anti-tip hardware to mount unit to a wall.
Use a mallet or hammer to tap the dowels into place.A Phillips screwdriver, drill and 17/64" drill bit are
required to complete assembly of the anti-tip wall strap.
©2013 The Container Store
®
Inc. All rights reserved. 18023 3/13
(H11) (H12)

©2013 The Container Store
®
Inc. All rights reserved. 18023 3/13
Item Description Quantity
Step 1
1. Use two long dowels (H1) to join the leg pieces as shown.
2. Make sure the dowels are fully inserted.
Step 2
1. Fasten the Desk Top (G) to the leg assembly (C+D) using a long
bolt (H4) and a binding screw (H3).
2. Attach the remaining shelves using a short bolt (H2) and a
short dowel (H5).
C
D
A
A. Right Upper Leg 1
B. Right Lower Leg 1
C. Left Upper Leg 1
D. Left Lower Leg 1
E. Top Shelf 1
F. Second Shelf 1
G. Desk Top 1
E
F
G
A
B
B
C
D
(H1) x 4+1 extra long dowel (H2) x 2 short bolt (H3) x 1 binding screw
(H4) x 1 long bolt (H5) x 2 short dowel
(H6) x 2 Allen wrench
C
D
E
F
G
(H4)
(H3)
(H2)
(H5)

Step 3
1. Fasten the right leg assembly (A+B) to the Desk Top (G) using a
long bolt (H4) and a binding screw (H3).
2. Use the short bolts (H2) and short dowels (H5) to fasten the right
leg assembly to the remaining shelves.
Step 4
1. Fasten the brackets (H11 & H12) to the Desk Top (G) using the 1/2"
pan head screws (H7).
2. Fasten the brackets to the legs using the 1" pan head screws (H8).
Step 5
1. If you purchased multiple units, use the mending plates to
connect them.
2. Locate the pilot holes (as shown) on the backs of the legs.
3. Use the small flathead screws (H10) to attach the mending plates (H9)
to the back of the unit.
Step 6
1. Locate the pilot hole and attach the wall strap (H16) to the back of
the shelf with the pan head screw (H15).
2. Position the unit against the wall in the desired location.
3. Mark the position of the strap hole on the wall.
4. Drill a 17/64" hole.
5. Tap in the wall anchor (H14).
6. Fasten the anti-tip wall strap with a wall screw (H13).
(H2) x 2 short bolt (H3) x 1 binding screw
(H4) x 1 long bolt (H5) x 2 short dowel
(H4) (H3)
(H2)
(H5)
A
B
This product must
always be mounted to a
wall. It is essential to use
wall anchors appropriate to
your wall type (e.g., plaster,
drywall, etc.). If you are
unsure about your wall type
or which mounting method
use, consult a qualified
professional. These
directions are for installation
into drywall; however, you
should mount to wood studs
whenever possible.
(H13) x 1 38mm wall screw (H14) x 1 wall anchor
(H15) x 1 panhead screw (H16) x 1 wall strap
(H9) x 2 mending plate (H10) x 4 flathead screw
©2013 The Container Store
®
Inc. All rights reserved. 18023 3/13
G
(H8)
(H7)
(H7)
(H8)
G
(H7) x 4 1/2" pan head screw
(H8) x 6 1" pan head screw
(H11) x 1 left bracket
(H12) x 1 right bracket

Weight Limit Warning
Do not exceed the recommended weight limits on the designated shelves. Exceeding these limits can cause sagging,
possibly resulting in shelf failure or bodily injury.
Top two shelves hold up
to 50 pounds each.
Desk Top holds up to 75 pounds.
©2013 The Container Store
®
Inc. All rights reserved. 18023 3/13