Thomas&Betts COMFORT CRIMP SHURE STAKE ERG2008 User manual

Figure 1
IMPORTANT: Read and understand all of the instructions
and safety information in this manual before operating or
servicing this tool.
COMFORT CRIMP®
ERG2008 SHURE STAKE®Tool
For Installing STA-KON®Non-Insulated Terminals
#8-1/0 AWG, TUBULAR ONLY
In the event the SHURE STAKE®MECHANISM must be released, please see Figure 4.
TA02406 D Page 1 of 2
1. Open handles
fully.
2. Depress wheel
release button
and rotate
wheel to proper
die nest. Allow
wheel to lock
into position by
releasing button.
For Use With STA-KON®Non-Insulated Terminals
Figure 3
Figure 2
1.1
1.0 INSTRUCTIONS FOR USE
3. Insert stripped
wire into
connector
and position
assembly in the
tool as shown.
4. Close handles
until the SHURE
STAKE®
mechanism
cycle has been
completed.
5. Perform two
equally spaced
crimps on each
terminal barrel.
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.

1.2
1.3
To release the SHURE STAKE mechanism, push up on the release bar until the
ratchet teeth are disengaged.
SHURE STAKE®Mechanism
1. Remove dust, moisture, and other contaminants with a clean brush or a soft, lint-free cloth.
2. DO NOT use on objects that could damage the tool.
3. Make certain all pins, pivot points, and bearing surfaces are protected with a THIN coat of any good
SAE No. 20 motor oil. DO NOT oil excessively.
4. Keep handles closed when not in use to prevent objects from becoming lodged in the crimping dies.
5. Store tool in a cool, dry area.
Maintenance
Figure 4
TA02406 D Page 2 of 2© 2008 Thomas & Betts. All Rights Reserved.
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine
the suitability of this product for the user’s intended application. Thomas & Betts warrants that this product will be free from
defects in materials and workmanship for the period stated on the enclosed warranty card. Upon prompt notification of any
warranted defect, Thomas & Betts will, at its option, repair or replace the defective product or refund the purchase price. Proof of
purchase is required. Misuse or unauthorized modification of the product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN
LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR
BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER
NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES.
Thomas & Betts Corporation
Memphis, Tennessee
www.tnb.com
For parts, service, repair and
calibration, contact the Thomas & Betts
Tool Service Center at 1-800-284-TOOL (8665).
WARNING
KEEP ALL BODY PARTS AWAY
FROM DIE NEST DURING
GAGING OR CRIMPING
PROCEDURE.