Thuasne ActionReliever Assembly instructions

To speed removal and
re-application of the
brace, simply unclip the
clasp 1and pull back
the loop 2to remove.
8
1
2
FITTING GUIDE
Osteoarthritis knee brace
ActionReliever
6
If creases form during the strap adjustment,
the angle of each strap can be adjusted.
Open the rear hook and loop openings on the
crossover self-gripping straps
Stand up
and take
a few steps
To adjust the tension
whilst wearing the knee
brace, simply re-position
the self-gripping tabs
Ref. 0117 092 019 - 01
7
Loop on left clasp
is for leverage when
closing clasp; don’t use it to
unclip, just use your ngers
For help and advice call our dedicated Helpline
on 01892 335877 or email [email protected]
Please refer to the instructions for use of the product before use. Last revision
date: 2019-10.
Watch our Fitting Video
by searching “ActionReliever tting video” on
Or with this QR code
THUASNE - 120 rue Marius Aufan
92300 Levallois Perret - France
www.thuasne.com
3:BBLRTB=V\UV^\:

Loosen all the straps
1
U
P
P
E
R
L
E
G
L
O
W
E
R
L
E
G
While sitting
down, pull-on
the knee brace,
ensuring
the patella
(kneecap) is
positioned in the
centre of the patella
ring. Patient should
stand to check no rucking
behind knee or at top of thigh
Sit down with the
knee bent at 70°.
Adjust lower
rear strap,
then higher
rear strap.
Straps should be
snug, not tight
To adjust strap
length, remove
the self-gripping
pad, shorten the
strap, re-attach
the pad on the
strap.
Make sure
that the
2 intersecting
self-gripping straps
are always positioned
centrally
2
3
4
L
O
W
E
R
L
E
G
U
P
P
E
R
L
E
G
Adjust the 2 front
straps in the same
way as the back
5