Time4Sleep SORRENTO Maintenance manual

SORRENTO
2 DRAWER BEDSIDE
Page 1of 3
210312
Warnings
Parts Identification
Do not place very hot or very cold items on
the furniture unless table mats are used to
prevent such items coming into direct contact
with the glass.
Do not strike the glass with hard or pointed
objects.
Do not use abrasive cleaners on the glass as
these may scratch and damage the glass.
To clean your item, use a soft cloth, slightly
dampened with water, and wipe clean. If
necessary, use a few drops of washing up liquid
on the cloth.
Then buff with a dry, clean cloth.
If the glass is chipped or broken and unsafe
to use, please contact your retailer.
Do not drag the cabinet across the floor, lift it
into position using two persons.
PLEASE READ this guide prior to installation, to familiarise
yourself with the various stages required.
Carefully open the pack supplied and check the
contents against the parts and fittings check list.
Do not destroy any of the packaging until you are
certain that you have all the necessary parts.
Please ensure that the packaging is disposed of in
a safe and environmentally friendly way.
Care & Maintenance
In the unlikely event of missing or damaged parts,
please email [email protected]
Please have this guide at hand quoting the part
code reference numbers shown, when requesting
spare or replacement parts.
1

Page 2of 3
Ref.Qty
1 1
Parts Checklist
Reversing the knobs
Description
2 Drawer Bedside Chest
Fittings Checklist
QtyRef. Description
A
B
x1
Qty
Ref. Description
x1
ii) Undo the screw and reverse
the knob re-fitting it on the
outside of the drawer front .
i) Open the top drawer
CCable tie
x1
Bracket for furniture -
pre-fitted by the factory.
Bracket for wall
Additional Tools Required
Cross-head Screwdriver
x
The knobs are mounted inside of the drawers to protect them during transit
Stage
1

Fitting instructions for anti-tilt brackets.
We advise that to prevent any entrapment or unforeseen accidents, you need to secure the furniture to your wall
in accordance with the following instructions. This is to prevent personal injury or property damage from
unexpected tipping over of the product, especially recommended when there are children in the home.
FURNITURE
(A)
WALL FURNITURE
1. The bracket (A) is pre-fitted to the furniture by the factory.
2. Position your furniture in the room deciding where on the wall the bracket (B) needs to be located - it
needs be close to, and in-line with (A) so they can be linked together. Move furniture aside and place
bracket on the wall and mark position of both screws with a sharp pencil.
3. Fix bracket to the wall using suitable wall fixings, remember that screws and wall fixings are not
included. Seek professional advice if unsure about a safe fixing method.
4. Feed small end of cable tie (C) down through wall bracket (B) then put furniture back in place.
5. Feed small end of cable tie up through the furniture bracket (A), push into receiving end of the tie.
6. Now pull tight.
Now your furniture is now protected from falling over.
Please do not allow children to climb on the product.
IMPORTANT: Screws or wall fixing are not included with your product as wall construction varies
considerably so please select a suitable fixing method for the type of walls you have in your home.
If you are unsure about what type of fixing you require seek professional advice.
The anti-tilt device must not be modified or altered in any way.
To secure Furniture to the wall:
Re-fitting the knobs
iii) Make sure the ferrule (x) is re-fitted
inside the holes, this is to prevent
cracking the glass - please do not
over-tighten the screws.
Repeat on the second drawer.
Safety Warning
Cable Tie
(C)
WALL
Fit one bracket
to the wall (B).
Bracket(s)
pre-fitted to
the furniture
Page 3of 3
(x)