Time4Sleep FLOOR STANDING HEADBOARD FIXING User manual

FLOOR STANDING HEADBOARD FIXING
ASSEMBLY INSTRUCTION GUIDE
Carefully unpack your headboard.
Do not use a knife to cut through packaging.
Assembly: 2 person
Required area: 1 x 2 metres
Required tools: cross head screwdriver
Important:
Please check that all the parts are present and read the instructions thoroughly before
commencing with assembly and retain them for future reference.
It is important to inspect all items BEFORE assembly, if for any reason you need to return this
item, you must return it in its original packaging. Assembled items CANNOT be returned.

Please check you have the correct ttings and read through before
commencing with assembly.
Supplied Fittings
33SR-20B 2019-11-15
x 0
x 6
E
Tips before you start:
We recommend that all items are assembled close to the place they will be in use and on a
protective surface to avoid any unnecessary movement or contact that may damage the product.
For ease during assembly identify the parts required before commencing each step, taking care to
avoid over-tightening the ttings as this may damage the furniture.
Safety:
Take extreme care when handling and lifting heavy products to avoid personal injury or damage
to the item. Keep children well away from the assembly area due to the heavy products as well as
choking hazard from small components.
Warning:
Please use this product for the specied purpose only, it is not to be stood on. If parts are missing,
broken, damaged or worn stop using the product until fully repaired.
Failure to follow safety and warning information could result in serious injury.
Recommendations:
Please periodically check all ttings and re-tighten if necessary.
To avoid re risks, warping and surface de-lamination keep away from strong heat sources and
never allow liquid to remain on your furniture. To clean, lightly dampen a soft cloth and wipe,
bu󰀩ng with a dry clean cloth.
STANDARD
WINGED
STANDARD HEADBOARD
1 x panel
WINGED HEADBOARD
1 x panel
2 x wings

Step 1
Fit headboard to bed using 4x
bolts that were supplied with
the bed base. These can be
tightened by hand.
Check your headboard is at
prefered height and level
before fully tightening.
Please Note:
This tting is not supplied
with the headboard, this is
supplied with the Divan/
Ottoman base.
x4
Quick Tip:
The metal insert may
be covered with fabric
- you may need to
make a small hole with
a bradawl to
t the bolts
Step 2
For Winged Headboard:
Attach wing sections using
6x bolts (E).
Manufactured by: Serene Furnishings Limited
Unit 1D, The Hill Top Estate, Shaw Street, West Bromwich, B70 0TX, United Kingdom