Timex M916 User manual

TIMEX
WATCH OPERATION GUIDE
TIMEX CONFIDENTIAL PROPRIETARY INFORMATION
Quality Control
Page 1 of 2
Model No(s):
M916
Part Name:
WATCH HEAD
Doc. No./Rev.:
20170418
Prepared by:
GTajantajan/HSagun
Approved by:
Reviewed by:
ACCabasan
DGriffith
M916 Watch Operation Guide Doc. No./Rev. 20170418
1.0 PURPOSE:
1.1 To provide Customer Service Centers with procedures on how to operate and set-up the Model 916 watch.
2.0 WATCH OPERATION AND SET-UP
2.1 HOW TO START YOUR WATCH
If the watch is provided with an e-guard (small plastic inserted between case and crown), it needs to be removed by
pulling downward (perpendicular to the back of the watch case).
2.2 TIME-OF-DAY SETTING
a. Pull the Crown out to SET 2 Position (second hand will stop moving).
b. Rotate the Crown to move the HOUR and MINUTE HANDS clockwise until correct time is displayed.
Note: Be sure to observe the AM or PM hands position when passing the 12 o’clock to 1 o’clock.
If date change occurs, time is on AM and if no date change, time is on PM.
c. Push the Crown in to the ZERO Position. The SECOND HAND should resume operation after one second.
2.3 DAY SETTING
a. Pull the Crown to the SET 2 Position.
b. Rotate the Crown in either direction until the current day is displayed.
c. Day should move forward or backward depending on the Crown direction.
d. Push the Crown in to ZERO Position.

TIMEX
WATCH OPERATION GUIDE
TIMEX CONFIDENTIAL PROPRIETARY INFORMATION
Quality Control
Page 2 of 2
Model No(s):
M916
Part Name:
WATCH HEAD
Doc. No./Rev.:
20170418
Prepared by:
GTajantajan/HSagun
Approved by:
Reviewed by:
ACCabasan
DGriffith
M916 Watch Operation Guide Doc. No./Rev. 20170418
2.4 QUICK DATE SETTING
a. Pull the Crown to the SET 1 Position.
b. Rotate the Crown in either direction until current date is displayed.
c. Date numeral should increase or decrease depending on the Crown direction.
d. Push the Crown in to ZERO Position.
Note: If above date setting occurs between 10 o’clock PM and 2 o’clock AM, the date numeral adjustment should only be in
the incremental direction.
2.5 NORMAL DATE SETTING
a. Pull the Crown to the SET 2 Position.
b. Rotate the Crown in clockwise direction until current date is displayed.
c. Push the Crown to ZERO Position.
Caution:
The CROWN must be returned to the ZERO Position after TIME-OF-DAY and/or DAY/DATE setting. Wearing or
storing the watch with the CROWN left in the SET 1 position will cause damage to its date mechanism.
2.6 INDIGLO ACTIVATION
This is applicable only on watch styles with the INDIGLO feature (M916).
Note: Models with this feature usually have the word “INDIGLO” printed on the watch display area.
Due to technical limitation, there are products that will show a small unlighted area at 6 o’clock or
12’oclock location of the dial. This is not a defect.
a. Push the Crown inward. Watch display will illuminate with blue-green or blue light.
b. Releasing the Crown back to the ZERO Position will turn off the INDIGLO light.