
–2 –
EN
Art. No. User Manual: 104828 ¬– Rev. A, 2021-05
EN
SV
3 Unfolding / Folding
Unfolding: Release the lock clamp
positioned at the seat bars (A). Press the
seat bars down and out. The side frames
will slide apart. Press down the seat bars
(B). You will hear a clicking sound. The
rollator is now locked in its open position.
Folding: Pull the strap on the seat (C)
and press the side frames together.
Lock the clamp (D) over the seat bars.
Carrying the rollator:The rollator must
not be carried by the seat strap or the
brake cables. Fold the rollator together
as shown on the illustration (E). Carry the
rollator by the seat bars (F) when folded.
4 Handles / Memory function
Height adjusting: Unscrew the lock
wheel (A) (approx. 2 turns). Adjust
the handle tubes to a suitable height
then pull them slightly up and down
(C) until you hear a clicking sound.
Tighten the lock wheel (A) again. Adjust
both handles to the same height by com-
paring the number scale on each side. It is
recommended that the handles are set to
the same height as your wrists when your
arms are hanging alongside your body.
Memory function: Decide on the height
of the handles (see number scale).
Count visible holes at the back of the
handle tubes. Unscrew the lock wheel
(A). Pull the tube (B) out of the frame. The
fastening piece (D) will now follow the
handle tube. Move the fastening piece
(D) so that the number of holes above it
equals to the previously counted holes.
Fit the red memory chip (E) on the handle
tube in the rst available hole under
the fastening piece (D). Push the handle
tube (B) down and into the side frame
(F) until the fastening piece is locked.
Screw the lock wheel (A) halfway in.
Pull the handle (G) up until it stops, and
then tighten the lock wheel (A) properly.
From now on, when the handle is in the
lowest position, it will stop in the pre-set
position automatically when pulled up.
5 Brakes
Make sure the brakes are working
before each trip. Each brake handle
(A) works on each of the rear wheels.
Do not drive or push the rollator
while the parking brakes are in use!
Parking brakes: Push both brake
handles (A) down until they lock.
Both rear wheels are now locked.
Squeeze both brake handles upwards
to release the parking brakes.
Driving brakes: Pull both brake
handles (B) upwards to reduce
speed. Do not use continuously
while the rollator is in motion.
Adjusting / checking: Loosen the nut
(C). Tighten the brake cable (D) with the
adjustment screw (E). Adjust the brake
block (F) as close as possible to the inner
drum brake, and then tighten the nut (C).
Turn the wheel around to check that the
brake block is not touching the wheel.
Maintaining: Clean the brake block
(F) and the brake spring (G) frequently.
The wheels and brakes can be replaced
if they are worn out or damaged.
6 Rear wheels
If you want to remove the rear wheels
for transportation or replacement,
follow these instructions:
Removal: Loosen the brake lever.
Push down the red button on the hub
(A) and slide the wheel o the axle (B)
while still pushing the button down.
Attachment: Loosen the brake lever.
Slide the wheel unto the axle (B). Push
the wheel as far as possible inwards on
the axle to make the wheel snap onto
the axle. You will hear a “click”when the
wheel is in place. The wheel is securely
fastened when the axle is completely
visible in the middle of the hub (C).
Gently pull the wheel to check that it is
securely fastened to the axle. After the
new wheel has been applied to the
rollator, make sure that the brakes are
functioning properly. Readjust them
if necessary (see section Brakes).
7 Seat
The parking brakes must be on before
using the seat. Push both brake handles
downwards until they lock (A). Both
rear wheels are now locked. Sit with
your back towards the bag (B).
8 Shopping bag
The bag holds up to 15 kilos and
can be washed gently at 60 °C.
Mounting: Apply the parking brake (A).
Lift the bag onto the carrying handles (B).
When it is placed correctly, you will hear
a click. Ensure that the brake wire still
runs unrestrained along the frame (C).
Removal: Apply the parking brake.
Place your hands towards the front of
the bag, on both sides. Lift the bag up
while pressing it slightly together.
9 Edge guard /Tilt function
Edge guard: The edge guards (A),
which are in front of the rear wheels
prevent the rear wheels from catch-
ing on corners, door frames etc.
Tilt function: To use the tilt function
use the front of the foot and press down
on the tilt pedal (B), which is beside the
rear wheel. This helps to tilt the rollator
over thresholds, edges etc. Please note:
Take care when descending kerbs.
10 TOPRO Ergo Grip
TOPRO Ergo Grip oers ergonomic grip
and support surfaces. The front of the han-
dles gives you a better gripping position
when getting up from a chair or couch.
Always make sure that the parking brake
is locked when you do this. The hand grip
also oers extra support while standing.
When pushing the rollator, your
hands should always be kept in the
original grip position to make the
best possible use of the brakes.
TOPRO Olympos ATR