
13
Höheneinstellung der
Unterarmauflagen
A
B
C
DE
FF
GFEF
HD
E
D
-
Empfohlene Höhe
I
Die Sternschrauben lösen (etwa 3-4
Umdrehungen). Das Handgriffrohr in der
gewünschten Höhe justieren und ein wenig
hoch und runter bewegen bis ein Einrasten
mit einem >Klick< erfolgt. Die Sternschraube
wieder gut festschrauben Beide
Unterarmauflagen auf gleicher Höhe justieren.
Wenn der Rollator transportiert oder gelagert
wurde, ist ein automatisches Wiederfinden der
einmal vorgenommenen Höheneinstellung
möglich. Zunächst die optimale Höhe der
Unterarmauflagen bestimmen. Dann die
sichtbaren Rasterlöcher am Handgriffrohr
zählen. Die Sternschraube ganz
herausschrauben. Das Handgriffrohr ganz
aus dem Rahmenrohr herausziehen.
Das Befestigungsstück folgt mit dem
Rahmenrohr. Das Befestigungsstück
darüber genau so viele
Rasterlöcher frei sind, wie vorher ausgezählt.
Den Memorystick im ersten Rasterloch unter
dem Befestigungsstück anbringen.
Schieben Sie das Handgriffrohr in das
Rahmen ück
Die Sternschraube
wieder anbringen und auf ca. halber
Einschubtiefe festschrauben. Das Rohr
hochziehen bis es stoppt, und die
Sternschraube fest anschrauben. Wenn Sie
jetzt die Handgriffrohre ganz nach unten
schieben und wieder hochziehen, wird auto
matisch die vorher eingestellte Höhe erreicht.
Mit entspannten Schultern und die
Ellbogen in 90 Grad Winkel stehen
Memoryfunktion
in eine
Position schieben, daβ
rohr, so daβ das Befestigungsst
sich in dem Kunststoffteil am oberen
Rahmenrohr verschlieβt.
Height adjusting
the forearm support
A
B
C
D
E
F
F
E
G
F
E
H
D
E
D
Recommended height
I
Unscrew the lock (approx. 3-4 turns).
Adjust the handlebar tubes to a suitable
height, then pull them slightly up and down
until you hear a clicking sound. Tighten the
lock again Adjust both the forearm supports
to the same height.
You have the opportunity to set the height of
the forearm supports as a standard so you
easily can find the height you once set. This
can be necessary when the walker is being
transported or stored as compact as possible.
Decide the height of the forearm support.
Count visible holes at the back of the
handlebar tubes. Unscrew the lock wheel
Pull the tube out of the frame.
The attached part will now follow the
handlebar tube. Move the attached part
on the tube so there are equal holes as
counted earlier. Fit the memory chip
on the handlebar tube in the first available
hole under the attached part
Push the handlebar tube down and into
the side frame until the attached part
is locked. Screw the lock wheel half in.
Pull the tube until it stops,
then tighten the lock wheel properly.
From now on, when the tubes are
in the lowest position, they will stop in the
preset position automatically when pulled up.
Stand upright with relaxed shoulders and
your elbows at a 90-degree angle
Memory function
ROLLATOR MIT UNTERARMAUFLAGEN
WALKER