
–4 –
EN
SV
Art. No. User Manual: 104841 – Revision D, 2022-01
EN
3 Unfolding / Folding
Unfolding: Release the lock clamp posi-
tioned at the seat bars (A). Press the seat
bars down and outwards. The side frames
will slide apart. Press down the seat bars
(B). You will hear a clicking sound. The
rollator is now locked in its open position.
Folding: Pull the strap on the seat (C)
and press the side frames together.
Lock the clamp (D) over the seat bars.
Carrying the rollator:The rollator must
not be carried by the seat strap or the
brake cables. Fold the rollator together
as shown on the illustration (E). Carry the
rollator by the seat bars (F) when folded.
4 Handles / Memory function
Height adjusting: Untighten the lock
wheel (A) (approx. 2 turns). Adjust the
handle tube to a suitable height then
pull it slightly up and down (C) until you
hear a clicking sound. Tighten the lock
wheel (A) again. Adjust both handles
to the same height by comparing the
number scale on each side. It is recom-
mended that the handles are set to the
same height as your wrists when your
arms are hanging alongside your body.
Memory Function: Decide on the height
of the handles (see number scale). Count
visible holes at the back of the handle
tubes. Unscrew the lock wheel (A). Pull the
tube (B) out of the frame. The fastening
piece (D) will now follow the handle tube.
Move the fastening piece (D) so that the
number of holes above it equals to the
previously counted holes. Fit the red
memory chip (E) on the handle tube in
the rst available hole under the fastening
piece (D). Push the handle tube (B) and the
fastening piece (D) downwards and into
the side frame (F). Screw the lock wheel
(A) halfway in. Pull the handle (G) up until
it stops, and then tighten the lock wheel
(A) properly. From now on, when the
handle is in the lowest position, it will stop
in the pre-set position when pulled up.
5 Brakes
Make sure the brakes are working
before every trip. Each brake lever
(A) works on each of the rear wheels.
Do not drive or push the rollator while
the parking brakes are in use.
Parking brakes: Push both brake
levers (A) downwards until they lock.
Both rear wheels are now locked.
Squeeze both brake levers upwards
to release the parking brakes.
Driving brakes: Pull both brake levers
(B) upwards to reduce speed. Do not use
continuously while the rollator is in motion.
Adjusting / checking: Loosen the nut
(C). Tighten the brake cable (D) with the
adjustment screw (E). Adjust both brake
blocks so the distance to the wheel
surface is approximately 1 mm (F) and
then tighten the nut (C). Make sure the
brakes are not adjusted too tight and
pressing hard into the rubber of the
wheels when the parking brake is on.
Maintaining: Clean the brake block
(F) and the brake spring (G) frequently.
The wheels and brakes can be replaced
if they are worn out or damaged.
6 Seat
The rollator has a safe and convenient
mesh seat, which provides view to the
ground while walking. It can easily
be wiped with a cloth if needed. The
parking brakes must be activated
before using the seat. Push both brake
levers downwards until they lock (A).
Both rear wheels are now locked. Sit
with your back towards the bag (B).
7 Edge guard /Tilt function
Edge guard: The edge guards (A),
which are in front of the rear wheels
prevent the rear wheels from catch-
ing on corners, door frames etc.
Tilt function: To use the tilt function
use the front of the foot and press down
on the tilt pedal (B), which is beside the
rear wheel. This helps to tilt the rollator
over thresholds, edges etc. Please note:
Take care when descending kerbs.
Basket
The bag holds up to 10 kilos (model M
& S) / 5kg (model X). It can be removed
and washed gently at up to 60 °C.
Transport
The rollator should be transported in
the folded and locked position (see
section Unfolding / Folding). Ensure that
the lock clamp is on, so that the rollator
cannot unfold unintentionally. Be
careful when loading the rollator into a
vehicle, giving attention to securing it.
Storage
The rollator should be stored in an upright
position. If stored outdoors it must be un-
der cover to protect it. Do not leave your
rollator unattended. Do not put heavy
items on top of the rollator during storage.
Cleaning
The rollator can be hosed and washed
with normal household detergents.
Machine washing in the dish cabinet
used at aid centres can be used (washing;
60 °C, 10 min. – drying; 70 °C, 10 min.). Do
not use abrasives. Avoid ushing directly
against bearings (wheels, front forks).