Toro Groundsmaster 4500-D Manual

All Rights Reserved
Printed in the USA
1
W2007 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Groundsmaster)4500-D and 4700–D
Groundsmaster Traction Unit
Model No. 30856—Serial No. 270000401 and Up
Model No. 30868—Serial No. 270000401 and Up
Form No. 3358–103 Rev. A
CE Compliance Set Up Instructions
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed. Some parts may have already been assembled at the factory.
Description Qty. Use
Lock bracket
Screw 1/4–20 x 1/2”
Washer .281 x .625
Lock nut 1/4–20
1
1
1
1
Install on hood latch for CE compliance
Lift latch
Latch bracket –R.H.
Latch bracket –L.H.
Flange lock nut 1/4–20
1
1
1
2
Install on control console for CE compliance
EEC decals 2Apply to machine for CE compliance.
EEC certificate 2
Installing the Hood Latch
1. Unhook the hood latch from the hood latch bracket
(Fig. 1).
2. Slide the hood lock bracket onto the latch (Fig. 1).
3. Hook the latch onto the hood latch bracket (Fig. 1).
4. Insert a bolt (1/4 x 1-1/2 in.) through the hood lock
bracket and secure it with a flat washer and locknut
(Fig. 1).
1
2
3
Figure 1
1. Hood latch
2. Hood latch bracket
3. Hood lock bracket

2
Install Cutting Unit Lift Latch
1. Rotate latches and remove control panel cover (Fig. 2).
2. Under front of control panel, locate ends of capscrews
securing control panel to frame (Fig. 2).
3. Insert left hand latch bracket up thru lift lever slot and
onto capscrew. Loosely secure with 1/4–20 flange nut
(Fig. 2).
4. Insert right hand latch bracket up thru lift lever slot and
onto capscrew. Loosely secure with 1/4–20 flange nut
(Fig. 2).
5. On top of control panel, insert each end tab of lift latch
into holes in latch brackets (Fig. 2). Tighten flange nuts.
1
5
4
6
3
2
Figure 2
1. Control panel cover
2. Control panel
3. Capscrews
4. L.H. latch bracket
5. R.H. latch bracket
6. Lift latch