Toro 07352 User manual

TORO DELUXE HARD CAB DOORS
This cab is manufactured for TORO
by Jodale Perry Corporation.
These door kits are intended to
be used on the following cab :
TORO WORKMAN®
MD Series cab
07328
Installation Instructions
Model’s 07352 & 07353
3362-138 Rev A
1. Safety instructions/Specifications..…………………………….2
2. Installation instructions…………….……………………………3
3. Warranty statement……………………………………………..5
Sliding Window Door
Kit Model 07352
Solid Window Door
Kit Model 07353
Table of contents

Safety Instructions
• Read and understand the contents of this material
before operating the vehicle. Become thoroughly
familiar with the controls, capabilities and proper
use of the equipment.
• Door kits fit all Workman®MD series cabs
• DO NOT weld, cut, drill, or modify door structure in
any way.
• Always use safety belts.
2
3362-138
Before Operating
Specifications
• Safety Glass with door seal mounted on a square
tube construction with key lock handles and air
shock opening and closing dampeners.
• Adjustable striker plates and striker pin for door
handle latch.
• Mounts to cab on quick attach hinges.
• 07352 Door kit has a drivers side sliding access
window.
• Weight of each door kit adds 84 pounds to vehicle
GVW and reduces rated capacity by the same
amount.

InstallationInstructions
1. Install brass washers on all 4 door
pins. See Figure 1.
Install brass washers
on door pins
3
Figure 1
Figure 2
Figure 3
3362-138
2. Install ball studs into tabs
provided in cab frame. Figure 2.
Door ball stud
3. Install doors on cab by
door pins with the hinge
part of the door. Figure 3.
Door hinges

Installation Instructions
4.
Figure 4.
Figure 5.
4. Install the door air shock onto ball
stud in door as shown in Figure 4.
Then install other end of air shock
on to cab ball stud. NOTE: Do not
over stress glass by trying to install
air shock on to cab as glass may
shatter. You may need to loosen
door stop mounting bolts to allow
door to open wider. See Figure 5.
Air shock
Door stop
Safety clips
5. After installing air shocks, install
safety clips on both sides of the
ball stud receivers, See Figure 4,
to ensure that the air shocks do
not fall off.
Figure 6.
6. Loosen striker pin on cab and
gently close the door and see
where the striker pin should be
located to keep the door closed
tight. Figure 6. Once located
in it’s proper location, tighten
all hardware and then repeat
steps 1 thru 6 for opposite
side door. Striker pin
Door stop
Mounting bolts

8.