Totally Wicked Skope S User manual

QUICK START GUIDE
For those familiar with e-cigarettes, the steps below can
be followed to allow the device to be used in the shortest
possible time:
• Prime the atomizer head
• Fill the tank
• Switch the Skope S on
• Press the power button and inhale
• Charge the battery (it may not have been shipped with
a full charge)
USING YOUR SKOPE S
Priming the Atomizer Head
Note: It is important to “prime” a new atomizer head before rst use. Failure to do so
can cause the atomizer coil to overheat, leading to an unpleasant taste and sometimes
irreversible damage to the atomizer head requiring early replacement.
To prime the atomizer head, remove the mouthpiece from the tank by unscrewing, then
remove the glass section of the tank by pulling upwards. Unscrew the atomizer head and
prime by dripping a few drops of e-liquid onto the cotton visible through the sides of the
atomizer. After priming, screw the atomizer head back into place, replace the glass section
and screw the mouthpiece back on.
Filling the Tank
Remove the mouthpiece from the tank by unscrewing.
Fill the tank with e-liquid, being careful not to overll and
avoid lling down the central airow hole. Once lled,
ret the mouthpiece.
Powering On and O:
To switch on, quickly press the power button ve times;
the indicator light will ash three times. Quickly press the power button ve times to turn
the battery o; the indicator light will ash three times.
Vaping:
Press and hold the power button as you inhale the vapour.
Power
Button
Charging Port
Skope S
Tank
Skope S
Battery
Note: Leave a new
atomizer head to sit with
the tank full of e-liquid
for ve minutes before
vaping. This ensures the
atomizer head is fully
saturated with e-liquid
before use.
USER MANUAL
CONGRATULATIONS ON PURCHASING YOUR
TOTALLY WICKED SKOPE S ELECTRONIC CIGARETTE KIT

E-liquid Level:
To prevent the atomizer head from
becoming dry and burning prematurely,
ensure the uid level does not drop below
the uid feed holes on the atomizer, these
can be recognised by the visible parts of
cotton on the atomizer.
Charging the Battery:
The Skope S is charged by inserting the
USB cable into the charging port. The
indicator light will illuminate red while
charging. Once fully charged, the red
indicator light will switch o.
Replacing the Atomizer Head:
To replace the atomizer head, follow the
steps outlined in Priming the Atomizer
Head to remove and separate the tank.
Prime your new atomizer head and
reassemble.
PROTECTIONS
Short Circuit Protection:
If an atomizer short circuit occurs, the
indicator light will ash three times and
the Skope S will switch o. Replace the
atomizer head and charge the battery to
restore power to allow normal operation
to resume.
No Atomizer Detected:
If no atomizer head is detected when the
power button is pressed, the indicator
light will ash continuously until the power
button is released. If this happens, ensure
the atomizer head is properly tted,
referring to appropriate instructions
above.
Atomizer Head Protection:
If the power button is held down for
longer than 15 seconds while vaping, the
indicator light will ash eight times and
the Skope S will switch o. Release the
power button and charge the battery to
restore power and allow normal operation
to resume.
Kit contents:
1 x Totally Wicked Skope S
2 x BFHN 0.5ohm atomizer heads
3 x Silicone rings
1 x USB cable
1 x User manual
Specications:
Dimensions: 14.0mm (diameter) x
113.0mm (length)
Weight: 38g
Battery capacity: 650mAh integrated
battery.
Output modes: Constant voltage
Max charging current: 1.0A
Max output voltage: 1.85V
Tank/Battery connection: All in one/
Proprietary connection.
Tank capacity: 1.2ml
Filling method: Screw top ll
Airow type: Non-adjustable
Max rell nozzle diameter: 2.8mm
ADDITIONAL PRODUCT INFORMATION
There are no reported medical side eects
with this product. If you believe you
experience a side eect, please contact
the manufacturer.
PRODUCT STORAGE AND BATTERY
PRECAUTIONS
• Store the Skope S and its accessories
away from children when not in use.
• Please only use the charging cable
provided.
• Please dispose of dead batteries
in accordance with your country’s
appropriate legislation.
• Do not charge the battery in a damp
environment, or in temperatures under
0°C or above 45°C.
• Do not use the device in temperatures
under -10°C or above 60°C.
• Do not carry batteries in a pocket or bag
with other metallic objects.
• Do not attempt to repair a faulty Skope S
battery as these are sealed units with no
serviceable parts. Attempted repairs will
void the warranty.
WARRANTY
The Skope S components have a 28 day
parts warranty, with the exception of
atomizer heads, which are consumable
items and covered by “dead on arrival”
warranty only. The USB cable supplied
has a 12-month warranty. If any parts are
found to be faulty within this time please
contact our customer service team, whose
details are below and we will arrange for a
replacement. We may require the goods to
be returned for further investigation.
Manufactured in China under the authority
of Pillbox38 UK Ltd, Stanclie Street,
Blackburn, Lancashire, BB2 2QR.
Tel [phone] www.totallywicked.co.uk
Tel [phone] www.totallywicked.com
Tel [phone] www.totallywicked.de