Toyota 74102-02140 User manual

TOYOTA/SCION/LEXUS See ‘General Applicability’ ASHTRAY
Preparation for Models/Years
Page 1 of 3 pages
Issue: B 4/25/13 DIO
Part Number: 74102-02140
Kit Contents
Item # Quantity Reqd. Description
1 1 Ashtray
2 1 Installation Manual
Hardware Bag Contents
Item # Quantity Reqd. Description
1
2
3
Additional Items Required For Installation
Item # Quantity Reqd. Description
1
2
3
Conflicts
Recommended Tools
Personal & Vehicle
Protection Notes
None
Special Tools Notes
None
Installation Tools Notes
None
Special Chemicals Notes
None
General Applicability
tC 2005-2010
xB 2008-2013
Sequoia 2008-
Tacoma 2005-
iQ 2012-
4Runner 2010-2013
GS350 2013-
GS450h 2010-2013
GS460 & GS350 2010-2011
RX350 2010-
RX450h 2010-
xB 2008-2013
Recommended Sequence of Application
Item # Accessory
1
2
3
*Mandatory
Vehicle Service Parts (may be required for reassembly)
Item # Quantity Reqd. Description
1
2
3
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
SAFETY TORQUE: This mark indicates that torque is
related to safety.

TOYOTA/SCION/LEXUS See ‘General Applicability’ ASHTRAY
Procedure for Models/Years
Page 2 of 3 pages
Issue: B 4/25/13 DIO
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this
accessory should follow approved guidelines to ensure a quality installation.
These guidelines can be found in the "Accessory Installation Practices" document.
This document covers such items as:-
Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).
Safety (eye protection, rechecking torque procedure, etc.).
Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
Please see your Toyota dealer for a copy of this document.
1. Install the Ashtray (Front Cup Holder).
(a) Insert the ashtray into the front cup holder of
the center console. (Fig. 1-1)
2. Install the Ashtray (Rear Cup Holder).
(a) Insert the ashtray into the rear cup holder of
the center console (Fig. 2-1)
3. Caution.
(a) When not using the ashtray, close the door.
While driving, a cigarette butt may drop out
of the ashtray if it is left open.
(b) Make sure to put a cigarette butt into the
ashtray after completely stubbing out the
lighted cigarette and close the door. Failure
to do so may cause a fire in the vehicle.
(c) Never put something inflammable such as
wastepaper in the ashtray or a fire may be
caused in the vehicle.
(d) Never drop the ashtray onto hard ground
surface or damage may result.
(e) Never apply excessive force to the ashtray
door when it is open or damage may result.
(f) Remove the ashtray slowly. Removing it
quickly may cause a cigarette butt drop out
of the ashtray.
(g) Open and close a vehicle door with the
ashtray door closed. A cigarette butt may
drop out of the ashtray if it is left open.
Ashtray
Fig. 2-1
Front
Center console
Ashtray
Fig. 1-1
Front
Center console

TOYOTA/SCION/LEXUS See ‘General Applicability’ ASHTRAY
for Models/Years
Checklist - these points MUST be checked to ensure a quality installation.
Check: Look For:
Page 3 of 3 pages
Issue: B 4/25/13 DIO
Accessory Function Checks
Ash cup
Vehicle Appearance Check
After accessory installation and removal of
protective cover(s), perform a visual
inspection.
Installed firmly in cup holder.
Ensure no damage (including scuffs and
scratches) was caused during the
installation process.
(For PPO installations, refer to TMS
Accessory Quality Shipping Standard.)