TP-Link MR-3020 User manual

Configuring TP-Link MR-3020
If reconfiguring device start at step 1.
If configuring for the first time, plug in device and skip to step 2.
1. Push the reset button on front of device for 15 seconds
2. Make sure device is set to WISP.
3. On your laptop or smart phone connect to the device using the SSID and password written on the back or side.
4. After connecting to device, input 192.168.0.254 in the address field end press enter.

5. Enter the word admin (lowercase) for both the username and password and click Login.
6. Click Nest to run the Quick Setup.
7. Choose Dynamic IP and click Next.

8. Choose No clone address and click Next.
9. Click Survey to find a list of visible wifi networks. Click Next.
10. Select the target wireless network and click Connect. Enter the password and Key type (probably WPA/WPA2)
and click Next.
11. Click Reboot for the configuration to take place.

12. You are done! Make sure an Ethernet cable is connected solidly from the MR-3020 to the monitor.