TP-Link AP300 V1 Quick start guide

How to upgrade TP-LINK Wireless Access Point
Notice:
Please verify the hardware version of your device for the firmware ver
sion.Wrong firmware upgrading may damage your device and void the
warranty.
After you downloaded the firmware from TP-LINK website, please use
decompression software such as WinZIP or WinRAR to extract the
firmware file to a folder;
It’s recommended to upgrade the firmware via Ethernet cable
connection but not wireless connection;
Do NOT turn off the power or cut down the Ethernet cable during
upgrade process;
Because after upgrading the old settings may be lost, so please write
down the key settings as a backup before you start to upgrade.
Step 1 Log into the TP-LINK device by typing http://192.168.0.254/ in the address bar
of the web browser (such as Internet Explorer, Firefox). The username and
password are both admin unless you have changed it before.

Step 2 Click System Tools ->Firmware Upgrade, click the Browse button to choose
the firmware you already extracted in the folder.
Step 3 Click the Upgrade button. The device will reboot automatically after the
upgrading has been finished. Please wait about 3 minutes.
Step 4 Click Status, verify that the device’s firmware has been upgraded.
Step 5 Then, check the status page of your device, if necessary please re-enter or
reconfigure the device manually with the parameters you have written down before
upgrading.