Trane AYSVPANL0022AA Series Assembly instructions

18-HE95D1-2
Service Valve Panel
Cover Kit
*AYSVPANL0022AA
*AYSVPANL0032AA
*AYSVPANL3343AA
*AYSVPANL3545AA
*AYSVPANL0044AA
*AYSVPANL0046AA
* A or T
Installer’s Guide
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
IMPORTANT —This Document is customer property and is to remain with this unit. Please return to service information pack upon completion of work.
WARNING:
HAZARDOUS VOLTAGE - DISCONNECT POWER and DISCHARGE
CAPACITORS BEFORE SERVICING
▲WARNING
!
This information is intended for use by individuals pos-
sessing adequate backgrounds of electrical and me-
chanical experience. Any attempt to repair a central air
conditioning product may result in personal injury and/or
property damage. The manufacture or seller cannot be
responsible for the interpretation of this information, nor
can it assume any liability in connection with its use.
▲WARNING
!
LIVE ELECTRICAL COMPONENTS!
During installation, testing, servicing, and troubleshoot-
ing of this product, it may be necessary to work with
live electrical components. Failure to follow all electrical
safety precautions when exposed to live electrical com-
ponents could result in death or serious injury.
Application:
This kit is to be used on outdoor units that do not ship
with a service valve panel cover. Part numbers for
kits are shown above. Panels vary by shape, size and
model color.
Contents:
1 - Panel
2 - 12-18 Screws
1 - Installer’s Guide
18-HE95D1-2
The manufacturer has a policy of continuous product and product data improvement and it reserves the right to change design and specifications without notice. Representative-only illustrations included in this document.
© 2014 Trane U.S. Inc. 10/14

6200 Troup Highway
Tyler, TX 75707
www.trane.com
www.americanstandardair.com
Procedure:
1. Place valve cover on unit by sliding
the tab(s) on the top of the valve
cover underneath the controls cover
(see Figures 1 and 2). Then push
the bottom of the valve cover in so
that the valve cover sits flush with the
controls cover and access panel.
2. Attach the valve cover to the unit
using (2) of the 12-18 screws in the
kit.
NOTE:
For alternate electrical routing, punch
out the knockout on the valve cover (as
shown in Figure 2).
Figure 1
Figure 2
2 18-HE95D1-2
Tabs
Ta b
Knock
Out