Travis Industries 33 DVI Cypress User manual

33 DVI, Cypress, DVL NB Log Set
Installation Instructions (sku 94500561)
Page 1 of 6 17601628 - 12/2/13 © Travis Industries, Inc.
Compatibility
•33 DVI Insert (with no media – 98400097)
•Cypress Stove
•DVL NB with Dancing-Fyre Burner
Packing List
•Rear Log
•
(2) Log Chunks
•Left Log
•
Rockwool
•Right Log
•
(2) 4 oz. Bags of Embers
•Left Twig
•Right Twig
Installation
WARNING:
•The logs are fragile, especially after being exposed to heat.
•Make sure the gas control valve is “OFF” and the heater is cool prior to conducting service.
•Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
•The burner must be correctly positioned before installing the logs. Make sure the burner is fully seated
and the pilot is properly aligned. See the owner’s manual for details on burner removal.
•Make sure the pilot shield and log plate are in place before installing the log set. It is shipped with
the burner.
HINT: If using propane (LP), convert the appliance before installing the log set.
Burner Air Deflector
Before placing the logs, make
sure the burner air deflector is
in the vertical position (see
illustration to the right).
CYPRESS WITH LP (PROPANE)
Rear Log Spacers
If using LP (propane), place the
rear log spacers (included with
the Cypress in the LP
conversion kit) as shown to the
right.

33 DVI, Cypress, DVL NB Log Set
Installation Instructions (sku 94500561)
Page 2 of 6 17601628 - 12/2/13 © Travis Industries, Inc.
Rear Log Placement
NOTE: The air deflector is used for natural gas (NG) configurations only. The air deflector is shipped with the burner.
IMPORTANT: Make sure the log plate and the pilot shield are in place.
The rear log has two holes on the bottom that fit over the two pins on the burner as shown above.

33 DVI/Cypress Log Set
Installation Instructions (sku 94500561)
Page 3 of 6 17601628 - 7/12/12 © Travis Industries, Inc.
Left Log Placement
Left Log Plate and Pilot Shield
NOTE: The left log plate and pilot shield are part of the burner assembly but are not mechanically attached.
Make sure both components are in place before placing the logs.
The left log has two holes in the bottom that fit over the pins on the burner as shown above.

33 DVI, Cypress, DVL NB Log Set
Installation Instructions (sku 94500561)
Page 4 of 6 17601628 - 12/2/13 © Travis Industries, Inc.
Right Log Placement
The right log has two holes in the bottom that fit over the two pins on the burner. Place the log as shown above.
Left Twig Placement
The left twig has a single hole on the
bottom that fits over the pin on the rear
log. Place the twig as shown in the
photos, noting how the twig points
inwards.

33 DVI, Cypress, DVL NB Log Set
Installation Instructions (sku 94500561)
Page 5 of 6 17601628 - 12/2/13 © Travis Industries, Inc.
Right Twig Placement
The right twig has a single hole on
the bottom that fits over the pin on
the rear log. Place the twig as
shown in the photos, noting how the
twig points inwards.
NOTE: The front of the twig may not
contact the right log – this is normal.
Log Chunk Placement
There are two log chunks that
are identical. Place them at
the front of the burner as
shown in the photos. Make
sure to not cover any burner
holes.

33 DVI, Cypress, DVL NB Log Set
Installation Instructions (sku 94500561)
Page 6 of 6 17601628 - 12/2/13 © Travis Industries, Inc.
Rockwool Installation
The included rock wool is placed on top of the burner to enhance the glow from the burner. The rock wool
works best when it is applied in a very thin, porous layer. The best method for applying the rock wool is
to brush it on to the burner. Compress a clump of rockwool between your thumb and forefinger. Use a stiff
brush to apply a thin layer of rockwool fibers onto the burner. Do not use the entire bag of rockwool. Use
only a small amount and save the remainder. Over-use of rockwool will diminish the glow and may cause
sooting or other adverse conditions.
Ember Placement
Place a layer of embers along the edges of
the burner, rivets, and along any edges to
enhance the aesthetics of the firebox. Do
not place embers over any burner holes.
See the photo to the right.
33DVI - Use one (1) bag of embers
Cypress - Use two (2) bags of embers
The completed log installation is shown below.