Travis Industries 99200139 User manual

Outside Air Kit
99200139
Page 1 of 2 17601452 - 2/21/20 © Travis Industries, Inc.
Compatibility:
•All Lopi Wood Stoves • Foxfire AGP
• Deerfield AGP
Packing List:
Outside Air Duct Assembly
Hood (includes rodent screen)
Flashing
3” Duct (4’ long)
Cover Plate
(2) Hose Clamps
(2) #8 Screws
(for securing air duct assembly to stoves with legs).
(2) 1” Wood Screws, (2) 1-1/2” Wood Screws, (2) Drywall Anchors (for
securing the hood and flashing)
Cover Plate (Required for Lopi Answer Wood Stove)
When using outside air with wood stoves the cover plate may be required to insure combustion air is drawn from below.
See the table and instructions below for details.
Answer Cover Plate Installation
Remove the air control stop on the stove.
Remove the bridge and plugs from the front of
the cover plate.
Re-attach the bridge to complete the cover plate installation.
Attach the air control stop and cover plate as
shown above. HINT: Place one screw through the
cover plate and air control stop, and while holding
them together, slide the components into place
and tighten the screws to secure.
Outside Air Knock-Out (Must be removed on the Lopi Answer Wood Stove)
On the Lopi Answer remove the forward knock-out on the bottom of the stove.
Outside Air Knock-Out
Rear Blower Knock-Outs
FRONT OF STOVE

Outside Air Kit
99200139
Page 2 of 2 17601452 - 2/21/20 © Travis Industries, Inc.
Installation
















































3" Dia. Flex Duct
(4' max. length)
Hood with Rodent Screen
Silicone
Seal the area around
the tube to prevent
air from entering
through the wall.
Silicone













All Stoves Except Leyden,
Arbor, Cape Cod:
Secure flex duct to air duct
assembly using the included
hose clamp. Attach air duct
assembly to stove with two
included #8 screws.
Slide the cover plate
over the flex duct then
attach the flex duct to
the hood with the
included hose clamp.
Secure the cover plate
to the wall with the
included screws (and
drywall anchors if
needed).
HINT: The flex must be
fully stretched and the
ends cut square and
flatted for it to fit
properly. The tube on
the hood and air duct
may be crimped if
necessary.

Cover Plate













Stove
b
8"
Select a location between
framing members for the
wall penetration.
NOTE: If wall is thicker
than 8", attach the flex duct
to the hood then slide the
hood into place.
c
Leyden/Arbor:
Remove the outside air cover
from the bottom of the stove.
Insert the start collar into the
air cover and tap into place
with a mallet. Secure the flex
duct to the start collar using the
included hose clamp.
Cape Cod:
Secure flex duct to air duct
assembly at the rear of the stove
using the included hose clamp.
a
Slide the hood
through the wall
and secure to the
outside wall with
the two included
screws.