Trust SECURITY PLUS-LINE ALMST-2000 User manual

SECURITY PLUS-LINE
ALMST-2000
ALMST2000 WIRELESS MAGNETIC SENSOR
USER MANUAL
MULTI LANGUAGE
Item 71113 Version 1.0
Visit www.trust.com
for the latest instructions

2
4
1
3
DELSET
DELSET
SET
2 sec
Red LED indicator

6
8
5
7

DELSET
DEL
2 sec
9
10
DELSET
DELSET
DELSET
DEL DEL DEL
2 sec 3 sec Short press

1
ALMST-2000 WIRELESS MAGNETIC SENSOR
1. Place batteries
Push with a sharp object on top of the magnetic sensor and pull o the backside. Insert two 1,5V AAA
Alkaline batteries in the slot. Observe the correct polarity of the batteries (place plus and minus on the
correct side).
2. LED indicator
The magnetic sensor has a LED indicator in the housing. The LED behaviour is as followed.
Low battery: LED will blink 3x every 6 sec
Confirm pair: LED will blink 5x
Confirm unpair: LED will blink 5x
3. Pair the ALMST
Consult the manual of the Siren to activate the learn mode. Send (while the learn mode of the Siren is
active) a pair-signal by pressing the SET button for 2 seconds with a sharp object next to the battery
slot of the magnetic sensor. The LED indicator will flash 5x to confirm that the pairing has been done
successfully.
4. Mount the ALMST
Place the magnetic sensor on the window or door and make sure that both points on the two parts
are in line with each other. Mark the top and bottom of both parts. After marking the positions remove
the sensor.
5. Remove backplate from the ALMST
Open the magnetic sensor by pushing with a sharp object on top of both parts and pull o the
backplate.
6. Fasten the ALMST
Screw or tape both backplates of the magnetic sensor on the window or door according to the made
markings. When securing the backplates make sure both parts are mounted with as little space
between as possible (max. 5mm).
EN

ALMST-2000 WIRELESS MAGNETIC SENSOR
2
7. Close the ALMST
Place both parts of the magnetic sensor back on the mounted backplates. Again make sure both
points on the two parts are in line with each other.
8. Operation of the ALMST
ON-signal: Once the two parts are separated more than 5mm from each other, the sensor sends an
ON-signal to the Siren.
Note: After arming the ALSIR-2000 there is a 85 sec walk-out time. 4 sec after arming the alarm
windows and doors can be opened for max 1 min. After 85 sec the sensor is active. Tip: Arm the Siren
from the outside.
9. Unpair the ALMST
Consult the manual of the Siren to activate the learn mode. Send (while the learn mode of the Siren
is active) a disconnect-signal by pressing the DEL button with a sharp object next to the battery slot
of the magnetic sensor. The LED indicator will flash 5x to confirm that the unpairing has been done
successfully.
Note: When the sensor is not used unpair it from the Siren first before removing it.
10. Delete ALMST memory
To delete the memory of the ALMST press the DEL button for 2 seconds with a sharp object (untill the
LED starts to blink). Release the button and press the DEL button again for 3 seconds. (untill the LED
starts to blink fast). Press the DEL button shortly to delete the memory of the ALMDT. The LED will
blink 5x to confirm the memory has been deleted.
EN

SECURITY PLUS-LINE
ALMST-2000
ALMST-2000 WIRELESS MAGNETIC SENSOR
Item 71113 Version 1.0
Visit www.trust.com
for the latest instructions
IMPORTANT INFORMATION
MULTI LANGUAGE

ALMST-2000 WIRELESS MAGNETIC SENSOR
1
EN
Legal information
CE: Trust declares this device complies with the Directives as listed in Section 2 of this document.
WEEE: Dispose of the device at a recycling centre. More information: www.trust.com
Warranty information: www.trust.com/warranty
COMPATIBILITY
The magnetic sensor works with the ALSIR-2000. FUNCTIONALITY Wireless magnetic sensor for activating the ALSIR-2000
when a door or window is opened/closed.
TECHNICAL SPECIFICATIONS
2x 1,5 Volt AAA alkaline battery (not included)
18 months stand-by
868 MHz 2-way communication
Up to 120 m (under optimal conditions)
LED will blink 3 times every 6 sec.
WIRELESS RADIO SIGNAL
• The 868 MHz signal passes through walls, windows and doors.
• Range up to 120 m (under optimal conditions).
• The strength depends on local conditions, such as the presence of metals. The metal particles in for example, double
glazing (HR glass), can provide a reduction in the range of wireless signals.
• There may be restrictions on the use of this device outside the EU. Check, if applicable, whether this device meets local
regulations.
Read the manual carefully. Failure to follow these instructions can be dangerous.
Incorrect installation will void any warranty on this product.
• Battery
• Battery life
• Frequency
• RF range
• Battery low indication
SMARTPHONE/TABLET FUNCTIONS
By combining this product with the OCTOPUS Control station, you can also set your alarm on / o via your tablet and / or
smartphone and receive push notifications when you are not at home.
For more information visit trust.com/71110

ALMST-2000 WIRELESS MAGNETIC SENSOR
2
EN
BATTERY
Remove the battery from the device if it is not used for a
long time. Extreme temperatures reduce the capacity and
lifetime of the battery.
Replace the batteries when the LED in the magnetic sensor
starts to blink 3 times every
6 seconds.
Batteries should not be chopped into pieces or burned.
Dispose of batteries according to local regulations. Deliver
them for the possibility to reuse. Do not throw batteries
away with the normal household waste.
LIFE SUPPORT
Never use Trust SmartHome products for life support
systems or other applications where failures can have life-
threatening consequences.
INTERFERENCE
Interference can aect the operation of all
broadcast transmitter and receivers negatively. The distance
between 2 receivers or transmitters should be at least
50 cm.
REPAIRS
Do not try to repair this product yourself.
The device contains no serviceable parts for the user.
WATER-RESISTANT
This product is not water-resistant.
CLEANING
Clean this product with a dry cloth.
Do not use harsh chemicals, cleaning solvents or strong
detergents.
MEMORY
The sensor can save up to 8 devices in its memory.
HANDLING
Do not drop the device, bump the device against something
or shake it. Rough handling can damage internal circuit
boards and fine mechanics.
ENVIRONMENT
The product should not be exposed to extreme heat or
cold. This can damage the circuit boards and batteries or
shorten its life.
DISCLAIMER
This product is a basic deterrent against intruders.
However, it remains the responsibility of the end-user to
adequately protect their home against break-ins. Therefor
Trust cannot be held responsible or liable for any damages
resulting from break-ins, trespassing, unauthorized access
or vandalism.

ALMST-2000 WIRELESS MAGNETIC SENSOR
50
EN
Declaration of conformity
Trust International B.V. declares that the
TrusT smarThome
-product:
model: ALMST-2000 Wireless magnetic sensor
item number: 71113
intended use: Indoor
is in compliance with the essential requirements and other relevant provisions of the following directives:
EMC Directive (2014/30/EU), Low Voltage Directive (2014/35/EU), ROHS Directive (2011/65/EC), R&TTE
Directive (1999/5/EC). The product is compatible with the following norms/standards:
Manufacturer/Authorised representative,
H. Donker, Procurement Director
Dordrecht, April 28 2016
EN 300-220-1 V2.4.1 (2012)
EN 300-220-2 V2.4.2 (2012)
EN 301489-1 V1.9.2 (2011)
EN 301489-3 V1.6.1 (2013)
EN 60950-1: 2006+A11: 2009+A1 2010+A12:
2011+A2 2013
EN 55014-1 : 2006+A1 : 2009+A2: 2011
EN 55014-2: 1997+A1: 2001 +A2: 2008
EN 50581: 2012
Trust International B.V.
LAAN VAN BARCELONA 600
3317DD DORDRECHT
NETHERLANDS
www.trust.com