U-Line H-5181 User manual

PAGE 1 OF 3 1220 IH-5181
PATIO FENCE
1- 80 0 -295 - 5510
uline.com
H-5181, H - 5182
H-5183
PARTS
TOOL NEEDED
For H-5181 only: For H-5182 and H-5183 only:
Post x 1 Bolt x 2
Tube
(H-5182 x 2)
(H-5183 x 4)
Panel
(H-5182 x 2)
(H-5183 x 3)
Nut x 2
Connector x 2
Base x 1
1. Insert each post into base and rotate 90º into
locking position. (See Figure 1)
2. Assemble aluminum tubes. Ensure they are fully
inserted and locked together using the groove and
small punched guide on matching tubes. Ensure
bolt holes at both ends of tube assembly are in
same direction. (See Figure 2)
INSTALLATION
Phillips
Screwdriver
Figure 1
Figure 2
90º
Male
End
Small Punched
Guide
Groove
Female
End

PAGE 2 OF 3 1220 IH-5181
INSTALLATION CONTINUED
3. Insert and slide aluminum tubes through top and
bottom holes of panels. Center panel onto tubes.
Nut holes should face up. (See Figures 3-4)
4. Slide plastic connectors onto ends of top and
bottom tubes and secure using bolts and nuts
provided. Ensure the connector pegs are facing up
for the upper tube and down for the lower tube on
both ends of the panel/tube assembly.
(See Figure 5)
5. Insert bottom plastic connector pegs into the holes
of the bases and position top plastic connectors into
posts. (See Figure 6)
CAUTION! Do not assemble more than three
panels between two posts.
To add another straight section of fence, repeat
steps 2-5 as needed.
6. For right angle fence
assembly, rotate the
corner post 45º before
installing the next section
of panels. (See Figure 7)
7. Fill each post and base with water, sand or any
other granular material as needed. (See Figure 8)
Figure 3
Figure 4
Figure 5
Connector
Peg
Hole
Hole
Connector
Peg
Figure 6
Figure 8
Figure 7

PAGE 3 OF 3 1220 IH-5181
INSTALLATION CONTINUED
8. Insert post caps onto posts and rotate 90º into
locked position. (See Figure 9)
9. Slide and angle fence into desired position.
(See Figure 10)
Figure 9 Figure 10
1
-800-295-551
0
uline.com
Completed
Assembly
Configuration
Examples