U-Line H-2563 User manual

0313 IH-2563PAGE 1 OF 2
1. Place the two A-Frame bases on a flat level surface.
2. Place one seat slat on each side of the A-Frame
bases. Align the pre-drilled holes.
3. Loosely attach seat slats to A-Frame base with the
3⁄" lag screws and washers using the socket wrench.
(See Figure 1)
Seat With Metal Brace x 2
A-Frame Base x 2
3⁄" Lag Screw x 23
Tabletop Support
(Different Angle) x 1
Power Drill (Or Screw Gun)
7/16" Socket Wrench
3" Deck Screw x 10 Washer x 23
Tabletop Support
(Equal Angle) x 2
Tabletop Board x 3
PARTS
ASSEMBLY
TOOLS NEEDED
Figure 1
H-2563
6' A-FRAME
PICNIC TABLE
1-800-295-5510
uline.com
π

0313 IH-2563PAGE 2 OF 2
ASSEMBLY CONTINUED
4. Align the pre-drilled holes of tabletop boards to the
table top support (of different angle). Attach using
3⁄" lag screws and washers. (See Figure 2)
5. Place the three tabletop boards on the A-Frame
bases. Align the pre-drilled holes with the A-frame
base. Loosely attach tabletop board slats to
A-Frame base with the 3⁄" lag screws and washers
using the socket wrench. (See Figure 3)
6. Loosely drill the two tabletop supports (of equal
angles) to the underside of the A-Frame table with
the different angle support in the middle using 3"
deck screws. (See Figure 4)
7. Make sure the table is square and tighten all lag
and deck screws.
NOTE: H-2565 Mounting hardware sold
separately.
Figure 2
Figure 3
Figure 4
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com