Ublox EVK-NINA-W101 User manual

Quick Start EVK-NINA-W10
To download the toolchain and software
development kit, follow the instructions
available at
http://esp-idf.readthedocs.io/en/latest/
get-started
NOTE: This EVK is intended for evaluation
purposes only and is not approved for
resale.
UBX-17056199 - R01
1. Overview 2. Software installation
NINA-W10 module
Reset button
U.FL connector
USB connector
UART indication
LEDs
RGB LED
Boot button

There are two EVK-NINA-W10 variants:
•EVK-NINA-W101 with antenna connector
•EVK-NINA-W102 with internal antenna
1. For EVK-NINA-W101, attach the
external antenna to the antenna cable
and connect to the U.FL connector.
2. Connect the EVK-NINA-W10 eval-
uation board to your PC using the
included USB cable.
3. Verify whether the USB drivers are
installed successfully.
NOTE: If the drivers have not installed
automatically, refer to the
EVK-NINA-W10 User Guide.
3. Setup and driver installation
The EVK-NINA-W10 includes a USB cable
for communication and powering the
evaluation board.
The EVK-NINA-W101 variant also includes
an external antenna and an antenna cable
to connect to the U.FL connector (these
are not included in EVK-NINA-W102).
Refer to the EVK-NINA-W10 User Guide
for a comprehensive description of the
evaluation kit features and functionalities.
4. Interfaces
For more information regarding the
EVK-NINA-W10, contact your nearest
u-blox support:
www.u-blox.com/contact-support
5. More information
UBX-17056199 - R01 Copyright © 2017, u-blox AG