Ultimaker 2 Extended User manual

26.11.2017
Installation Guide
Ultimaker 2+ and 3, Magnetic Base
Plate

These are installation instructions for the GeckoTek Magnetic Base for
the Ultimaker 2, 2+, Extended and Ultimaker 3. When you are finished,
you will be able to use GeckoTek Build Plates without the need for
clips or tape.
The install was demonstrated on a Z stage that was removed from
the 3D printer. This was done for convenience and to allow for
better pictures and is not necessary or recommended.
If you have questions or discover an issue with the installation process,
please let us know.
Total install time is 5-10 mins.
You will need the following to complete the installation process:
•M2x5 screws (included)
•Thin Phillips screwdriver
•Pliers or wrench
Step 1: Remove the stock glass build platform by rotating the
retaining clips out of the way and sliding the glass plate forward.
Step 2: Loosen the 3 leveling screws that hold the print bed heater on.
Remove the thumb nuts and screws and set them aside for later.
Step 3: Using a wrench, loosen the screws attaching the power and
thermistor wires to the print bed heater. You should not be able to
separate the print bed heater from the 3D Printer.

Step 4: The front two glass retaining clips will come off with the
leveling screws. Using the allen wrench and pliers, remove the screws
holding the back two clips on. Set the screws and nuts aside for later.
Step 5: Attach the Magnetic Base to the stock bed heater using the
included M2.5 Screws. The mounting holes in the Magnetic Base line
up with the small slots where the retaining clips that held the glass
plate used to be.

Step 6: Attach the Magnetic Base with heater attached to the Z-
carriage with the 3 leveling screws. Tighten finger tight with the thumb
nuts and Phillips screwdriver.
Step 7: Attach the GeckoTek Build Plate to the Magnetic Base and
center it. Then follow the manufacturer’s recommended bed leveling
procedure with the Build Plate in place.
You are now ready to 3D Print with your GeckoTek Build Plate!