Unfinished Furniture of Wilmington EMPIRE CHAIR WITH RUSH SEAT C-1200 User manual

ITEM
NO.
:
C
-
1200
REVISED AUG 04, 2012
Printed in Vietna
- 1 -
Description
Item No.
: EMPIRE CHAIR WITH RUSH SEAT
: C-1200
ASSEMBLY
INSTRUCTIONS

ITEM
NO.
:
C
-
1200
REVISED AUG 04, 2012
Printed in Vietna
- 2 -
BEFORE ASSEMBLY
T ank you for purc asing t is quality product. T is product as been designed for easy assembly and
constructed for durability. All parts were c ecked prior to packaging to insure quality. Prior to beginning
assembly, owever, make sure all parts and ardware are included and free of obvious defect. If a part is
missing or defective, please contact t e store w ere purc ased. If ardware is missing, or you need elp wit
assembly, please call toll free 888-944-8396.
.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smoot surface suc as a rug or carpet to avoid t e parts from
being scratc ed.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tig ten all screws and bolts until completely assembled.
- Keep all ardware parts out of reac of c ildren
PART LIST
W en unpacking, please be careful not to discard any parts wit t e packaging. Before continuing,
please make sure you ave t e following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Back 1 B Seat Frame 1
C Front Leg
(L-R) 2
D Front
Stretc er 1
E Side stretc er
- Upper 2
F Side stretc er
- Lower 2
G
.
Seat
1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM
NO.
:
C
-
1200
REVISED AUG 04, 2012
Printed in Vietna
- 3 -
HARDWARE LIST
W en unpacking, please be careful not to discard any parts wit t e packaging. Before continuing,
please make sure you ave all of t e following ardware:
NO Description Qty Sketch NO Description Qty Sketch
1
S ort bolt
(M6x40mm)
3 2
Medium bolt
(M6x60mm)
4
3
Long bolt
(M6x80mm)
4 4
Flat Was er
( Φ6.5xΦ19mm)
11
5
Lock Was er
( Φ6.5xΦ11mm)
11 6
Screw
(M4x35mm)
6
7
Allen Key
(4mm)
1 8
Screw
(M4x40mm)
4
STEP 1
Attac seat frame (B) to back (A) by using bolts (3) and (1), and was ers (4) and (5).
Note: DO NOT tig ten any of t e bolts, until t e c air is fully assembled. Put t e c air on a flat level
surface, make sure t e c air is level and tig ten wit allen key (7) as s own below.

ITEM
NO.
:
C
-
1200
REVISED AUG 04, 2012
Printed in Vietna
- 4 -
STEP 2
Attac front legs (C) to t e seat frame wit bolts (2) and was ers (4) and (5). Tig ten wit Allen Key
(7).
Attac front stretc er (D) between front legs, attac side stretc ers (E) and (F) between front and
back legs wit screws (6). Tig ten wit a screwdriver.
.
STEP 3
Attac t e seat (G) to top of t e seat frame (B) by using screws (8). Tig ten wit a screwdriver.